The Defense Advanced Research Projects Agency (DARPA) has introduced a Wideband Adaptive RF Protection (WARP) program, aimed to protect wideband receivers operating in congested and contested electromagnetic (EM) environments.
The goal is to develop wideband, adaptive filters and analog signal cancellers that selectively attenuate or cancel externally generated interference signals (from adversarial jamming, for instance) and self-generated interference signals (like those created by a radio’s own transmitter) to protect wideband digital radios from saturation.
Today’s electromagnetic spectrum is a scarce resource that is becoming increasingly congested and contested as friendly, unfriendly, and neutral entities vie for available spectrum resources at any given time, location, and frequency. Within the Department of Defense (DoD), radio frequency (RF) systems, such as communications networks and radar, must operate within this congested environment and contend with mission-compromising interference from both self and externally generated signals.
A desire to support wideband EM spectrum operations also adds to the burden because current approaches to mitigating wideband receiver interference are sub-optimal and force compromises around signal sensitivity, bandwidth usage, and system performance. Further, in the case of self-interference, traditional mitigation approaches such as antenna isolation alone are often not sufficient for protecting wideband receivers.
Saturation occurs when the power level of a received signal exceeds the receiver’s dynamic range – or the range of weak to strong signals it can handle. When exposed to interference or jamming, the target WARP components will sense and adapt to the EM environment through the intelligent control of adaptive hardware.
To address external interference, WARP will explore the development of wideband tunable filters that can continuously sense the EM environment and adapt to maintain the receiver’s dynamic range without decreasing signal sensitivity or bandwidth. The research will look at innovative filter architectures supported by state-of-the-art components and packaging to achieve the program’s target metrics.
With the WARP filters, the goal is to reduce the effect of large signals without attenuating smaller signals. By attenuating the large signals, a wideband RF system is better able to listen to both weak and strong signals over a wide bandwidth.
WARP will also address self-generated inference with the development of adaptive, analog signal cancellers. Sometimes a system’s own transmitter is the biggest interferer to the receiver. To avoid this issue, transmitting and receiving at different frequencies has traditionally been commonplace, aided by the use of a frequency duplexer to keep the two bands separate. However, for defense systems, there are a number of benefits to transmitting and receiving on the same frequency – such as doubling spectrum efficiency and increasing network throughput. This concept is referred to as same-frequency simultaneous transmit and receive (STAR).
The use of same-frequency STAR has been limited due to the few available means of ensuring the transmitter leakage does not interfere with the receiver. To combat this, WARP will explore analog cancellers that will reduce the transmit leakage before the wideband digital receiver, such that any residual leakage will be sampled and further canceled in the digital domain.
Dr. Timothy Hancock, DARPA program manager, stated, Through WARP’s technological developments, their ability to reduce critical interference issues and protect wideband radios will significantly improve. Further, if successful, these technologies will enable the use of software-defined radios (SDRs) in congested and dynamic spectral environments – something that is limited today.
DARPA is hosting a Proposers Day meeting on February 11, 2020, in Arlington, Virginia, to provide more information about WARP to interested researchers.
Click here to find out more information.
