RF Industries has releases two new N Type male connectors that simplify the installation of connectors onto coaxial cables by eliminating the need to trim the braid during cable preparation. The RFN-1006-49I features a solderless captive pin and the RFN-1006-4I features a crimp pin. Both connectors are compatible for high performance cables such as Times Microwave LMR®-400, CommScope CNT®-400, Belden 9913, and RF Industries RFI-CU400™. Combination hex/knurl coupling nuts allow for tightening by hand or wrench. White Bronze (tri-metal) plating eliminates tarnishing while providing improved electrical performance and reduced PIM (Passive Intermodulation). Exceptional VSWR of less than 1.10 to 1 up to 3Ghz and less than 1.20 to 1 up to 8Ghz is achieved through an enhanced impedance matching design. Industry standard tooling can be used for cable preparation and crimp termination. Heat shrink and assembly instructions are included with each connector. These connectors aim to simplify the proper installation of rf connectors on to coaxial cables which is critical for wireless system performance.