New RF and Microwave Products this Week |
|
|
|
|
|
|
10 Mbps LTE Cat 1 Module for M2M and IoT Applications |
Cellular Module
from Quectel
|
The LTE EG800Q-EU from Quectel is an LTE Cat 1 Module that is designed for M2M and IoT applications. It is based on 3GPP Rel-14 LTE technology and delivers a downlink data rate of up to 10 Mbps and an uplink data rate of 5 Mbps. This module is based on the Qualcomm QCX216 LTE IoT Modem for customers in Europe, the Middle East, Africa, Australia, New Zealand, and Israel markets with LTE FDD band coverage of bands B1/3/5/7/8/20/28. |
|
Download Datasheet
Product Details | |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Sponsored by Quantic Wenzel | | |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Ultra-Wideband Power Amplifier from 0.5 to 80 GHz |
RF Amplifier
from Mini Circuits
|
The ZVA-5803X+ from Mini-Circuits is a Power Amplifier that operates from 0.5 to 80 GHz. It delivers a saturated output power of 15.5 dBm with a gain of 17 dB. This amplifier has internal DC-DC conversion circuitry that maintains constant efficiency over the full input voltage range. It incorporates several DC-protection features, such as over-voltage, reverse voltage, and in-rush current, that protect it from damage if mishandled during operation. |
|
Download Datasheet
Product Details | |
|
|
Sponsored by Quantic Wenzel | |
|
|
4-Channel Satellite Link Emulator |
Satellite Link Emulator
from dBm Corporation
|
The SLE9250 from dBm Corporation is a Satellite Link Emulator that provides the cost-effective, time-saving, repeatable total solution for the satellite to ground station RF link testing. The emulator can accurately simulate propagation delays, flat fading, path loss, phase shift, and Doppler shifts let systems engineers create realistic, full-duplex path scenarios for closed-loop testing of satellites, ground processing equipment, and mobile transceivers. |
|
Download Datasheet
Product Details | |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
3D Wireless Prediction Software |
Software
from Remcom
|
Wireless InSite® is a suite of ray-tracing models and high-fidelity EM solvers for the analysis of site-specific radio wave propagation and wireless communication systems. The RF propagation software provides efficient and accurate predictions of EM propagation and communication channel characteristics in complex urban, indoor, rural and mixed path environments. |
|
Download Datasheet
Product Details | |
|
|
|
Low-Power OCXO from 30 to 300 MHz |
OCXO
from Dynamic Engineers
|
The OCXO3322AW02 from Dynamic Engineers is an Oven Controlled Crystal Oscillator (OCXO) that operates from 30 to 300 MHz. It provides a sine wave or HCMOS output with a frequency stability of ±10 ppb and an SSB phase noise of -158 dBc/Hz (@ 10 kHz offset). This OCXO requires a DC supply of 3.3/5 V and consumes less than 230 mW of steady-state power. |
|
Download Datasheet
Product Details | |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Test & Measurement Instrumentation Amplifier from 2 to 18 GHz |
RF Amplifier
from Maury Microwave
|
The MPA-2G-18G-50 from Maury Microwave is a GaN Power Amplifier that operates from 2 to 18 GHz. It delivers a saturated CW output power of 50 W with a small signal gain of more than 49 dB. This instrumentation amplifier is burn-in, and aging tested for high reliability which includes prolonged storage under extreme temperature conditions, extended amplifier operation over the entire rated temperature range, and elongated usage at maximum power under CW and pulsed-CW conditions. |
|
Download Datasheet
Product Details | |
|
|
|
|
|