| New Products Showcased at IMS 2023 . |
|
|
| 8 W GaN Doherty Power Amplifier Module from 3.4 to 3.8 GHz | |
RF Amplifier
from Qorvo
|
| The QPB3810 from Qorvo is a Doherty Power Amplifier Module that operates from 3.4 to 3.8 GHz. It delivers an output power of 39 dBm (~8 W) and has an integrated bias controller that is factory programmed to set optimal bias points. This 2-stage GaN power amplifier includes a temperature sensor and adjusts bias over temperature along with an enable pin for fast TDD switching. It is ideal for 5G m-MIMO wireless infrastructure. |
| |
Download Datasheet
Product Details | |
|
|
|
| High-Linearity SPDT MEMS Switch from DC to 34 GHz | |
RF Switch
from Analog Devices
|
| The ADGM1001 from Analog Devices is an SPDT MEMS Switch that operates from DC to 34 GHz. It can handle an input power of up to 33 dBm and has an insertion loss of less than 1.5 dB. The switch provides 32 dB of isolation, has a switching time (ON/OFF) of 200 µs, and a power-up time of 4 ms. It is fabricated using Analog Devices’ micro-electromechanical system (MEMS) switch technology which enables a small form factor, wide RF bandwidth, highly linear, and low insertion loss that is operational down to DC. |
| |
Download Datasheet
Product Details | |
|
|
|
| 8 GHz SP4T Switch for Massive MIMO 4G/5G Base Stations | |
RF Switch
from pSemi, A Murata Company
|
| The PE42446 from pSemi is an SP4T Switch that operates up to 8 GHz. This switch integrates seamlessly into 4G and 5G base stations and mMIMO architecture, providing digital pre-distortion (DPD) feedback loops and transmitter monitoring signal paths to prevent interference and maintain signal integrity, given massive MIMO applications. It provides more than 60 dB of isolation to prevent interference and maintain signal integrity and has a switching time of 250 ns. |
| |
Product Details | |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Sponsored by Digi-Key | | CMPA0530002S GaN HEMT MMIC | | The CMPA0530002 is a packaged GaN High HEMT-based MMIC that operates on a 28 V rail while housed in a 3 mm x 4 mm; surface mount; dual-flat-no-lead (DFN) package. Under reduced power; the transistor can operate below 28 VDD to as low as 20 VDD maintaining high gain and efficiency. Click here to learn more. | | | |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Real-time Spectrum Analyzer from 100 kHz to 43.5 GHz | |
RF Spectrum Analyzer
from Signal Hound
|
| The SM435C from Signal Hound is a Real-time Spectrum Analyzer that operates from 100 kHz to 43.5 GHz. It has a dynamic range of 110 dB, a sweep speed of 1 THz/sec at 30kHz RBW (using Nuttall windowing), and an SSB phase noise of -138 dBc/Hz@100 kHz offset. This RTSA is designed for remotely-located accurate RF data analysis at the lowest cost possible and includes a 10 Gigabit Ethernet SFP+ port, enabling it to communicate with a PC over long distances using a fiber optic cable. |
| |
Download Datasheet
Product Details | |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Low-Noise, High-Speed DAC Interface IC from 3 to 16 GHz | |
RF Amplifier
from mmTron Inc
|
| The TMC160 from mmTron is a DAC Interface IC that operates from 3 to 16 GHz. It amplifies and converts the differential output of a high-speed DAC to a clean, low-noise, single-ended signal to drive the RF chain of a transmitter. This IC integrates anti-alias lowpass filtering, low noise amplification, and a balun that converts the differential DAC output to a single-ended 50-ohm output compatible with traditional RF signal chains. |
| |
Download Datasheet
Product Details | |
|
|
|
|
|
|
|
|
| 1 W Gain Block Driver Amplifiers from 2 to 20 GHz | |
RF Amplifier
from Narda-MITEQ
|
| The MPAS Family from Narda-Miteq are Medium Power Amplifiers (MPAS) that operate from 2 to 20 GHz. They provide up to 40 dB of gain with a noise figure of less than 7 dB and have a P1dB of 1 W. These amplifiers include built-in thermal protection and reset, and an over/under current alarm. They offer improved matching for ease of design and integration and reduced power consumption through electronic (TTL) On/Off switch capability. |
| |
Download Datasheet
Product Details | |
|
|
|
|
|
|
|
|
|
|
|
