1. everything RF
  2. RF Newsletters
more
PREV 14th June, 2017 NEXT

New RF & Microwave Products this Week

14 June, 2017 - everything RF Newsletter
 
everything RF
Date: 14 June, 2017
 
Sponsored by Mouser
 
 
 
Latest RF & Microwave Products this Week
RF Spectrum Analyzer
High-Performance Signal Analyzer for 5G Signal Measurement

RF Spectrum Analyzer from Anritsu

The MS2850A from Anritsu is a mid-range Signal Analyzer that offers 1 GHz analysis bandwidth supporting evaluation of 5G multi-carrier signals. The analyzers are available in two frequency options 9 kHz to 32 GHz and 44.5 GHz. By using the 5G measurement software packages, the MS2850A uses high dynamic range and excellent flatness performance to cut measurement times using all-at-once, high-accuracy measurements of a typical 800 MHz modulation bandwidth to be used in 5G.
 
Download Datasheet | Product Details
 
RF Amplifier
Broadband LNA/Linear Driver from 0.1 to 3.8 GHz

RF Amplifier from Guerrilla RF

The GRF4014 is a low noise amplifier/linear driver that can be tuned from 100 MHz to 3800 MHz. The device can cover 1700 to 3800 MHz with a single set of external components. At 2500 MHz, it provides a gain of 17.0 dB with a noise figure of 0.73 dB. The LNA delivers a P1dB of 24.8 dBm, OIP3 of 38 dBm while operating at 5.0 volts and consuming 65 mA of current.
 
Download Datasheet | Product Details
 
RF Cable Assembly
DC to 50 GHz Flexible VNA Test Port Extension Cables

RF Cable Assembly from MegaPhase

The High Performance VN Series Cable Assemblies from MegaPhase are VNA Test Port Extension Cables that operate up to 50 GHz. These VNA cable assemblies are designed to ease the time associated with test equipment calibrations where compensation for loss, mismatches, and feedthroughs are critical to the test outcome. The VN series cables are mechanically stable and can be bent with minimal effect on insertion loss, phase or VSWR.
 
Download Datasheet | Product Details
 
OCXO
G-Compensated OCXO from 5 to 130 MHz

OCXO from Bliley Technologies

The Poseidon Series are G-compensated OCXO's from Bliley Technologies that operate from 5 to 130 MHz. They have been specifically designed for high vibration environments where dynamic phase noise performance is of extreme importance. The active compensation and passive isolation provide up to 100x improvement in acceleration sensitivity over standard oscillators.
 
Download Datasheet | Product Details
 
Termination
100 Watt Termination from DC to 6 GHz

Termination from JFW Industries

The 50T-390 Termination from JFW Industries operates from DC to 6 GHz and can handle up to 100 watts of power. It is matched to 50 ohms and has a VSWR of less than 1.35:1 across the band. It is available with a round heatsink and N Type or 7/16 DIN Male/Female connectors.
 
Download Datasheet | Product Details
 
RF Amplifier
6 to 18 GHz GaAs pHEMT MMIC Wideband Low-Noise Amplifier

RF Amplifier from Microsemi

The MMA044PP3 is a GaAs pHEMT low-noise wideband amplifier that operates from 6 to 18 GHz. It provides 17 dB of gain with a noise figure of less than 2 dB and P1dB of 14 dBm and output IP3 of 28 dBm. The LNA requires a 4 V supply and draws 100 mA of current. The P1dB power of 14 dBm enables the LNA to function as an LO driver. The RF input and output ports are DC blocked and internally matched to 50 Ohms.
 
Download Datasheet | Product Details
 
Sponsored by Mouser
MRF1K50H
Mouser Ships NXP MRF1K50H 1500W RF Power Transistor
NXP MRF1K50H 1500W RF Power Transistor offers high RF output power, ruggedness, and thermal performance. The MRF1K50H delivers 1.50kW CW at 50V and decreases the number of transistors in high-power RF amplifiers. The I/O design of the MRF1K50H allows for wide frequency range use from 1.8 to 500 MHz. Click here to learn more.
 
 
 
RF Shielded Test Enclosure
RF Shielded Test Enclosure for 802.11 a/b/g/n/ac, Bluetooth, RFID and 3G Device Testing

RF Shielded Test Enclosure from RF Electronics

The HDRF-2570 from RF Electronics is a RF Shielded Test Enclosure that operates from 20 MHz to 6 GHz (different models up to 60 GHz are also available). It has a thick RF absorbing foam that provides an isolation of up to 120 dB and return loss of 25 dB with IO panels installed. The enclosure has shielded power filters for providing power connection in the box while blocking all wireless signals.
 
Download Datasheet | Product Details
 
Fixed Attenuator
Low PIM Fixed Attenuator from DC to 6.5 GHz

Fixed Attenuator from API Technologies - Weinschel

The Model 254 LIM from API Weinschel are low PIM fixed attenuators that operates from DC to 6.5 GHz. This series of attenuators are available in multiple attenuation configurations from 10 to 40 dB (10, 20, 30 and 40 dB) and have a low PIM of up to -150 dBc. The Attenuators can handle up to 175 watts of average power and 10 kilowatts of peak power.
 
Download Datasheet | Product Details
 
Signal Generator
High Performance Analog Signal Generator up to 20 GHz

Signal Generator from Rohde & Schwarz

The R&S SMA100B from Rohde & Schwarz is a powerful analog signal generator with a frequency range up to 20 GHz. It can generate signals with the a very low phase noise and low harmonics while delivering a high output power. The device can provide high-level signals with extremely low, close-in phase noise of less than -152 dBc at 1 GHz and less than -132 dBc at 10 GHz, each at 20 kHz offset.
 
Download Datasheet | Product Details
 
RF Amplifier
20 W Solid-State Amplifier from 6 to 18 GHz

RF Amplifier from AR RF/Microwave Instrumentation

The 20S6G18A from AR RF/Microwave Instrumentation is a portable, self-contained, air-cooled, solid-state microwave amplifier that operates from 6 to 18 GHz. It delivers over 20 watts of CW output power with a gain of more than 43 dB. The amplifier is ideal for RF susceptibility testing, antenna/component testing, and communication technology testing. The 20 watt model can be expanded to 40 watts inside the same cabinet.
 
Download Datasheet | Product Details
 
Antenna
High-Performance, Ruggedized GPS Passive L1 Antenna

Antenna from Southwest Antennas

The 1027-010 from Southwest Antennas is a high-performance, ruggedized GPS Passive L1 Antenna designed for GPS receivers, manpacks, hand-held, and small form factor radio systems. The antenna delivers a gain of 1.5 dBic and has a VSWR of 2.0:1. It has an integrated 3.42 inch RF coaxial gooseneck assembly which is sealed with Polyolefin heat shrink providing a waterproof seal to 20 meters / 65.6 ft.
 
Download Datasheet | Product Details
 
RF Amplifier
20 dBm W-Band Power Amplifier from 75 to 110 GHz

RF Amplifier from SAGE Millimeter

The SBP-7531142515-1010-E1 from SAGE Millimeter is a power amplifier that operates from 75 to 110 GHz in the W-band. It provides a saturated output power of 20 dBm with a gain of 25 dB. The amplifier requires a supply voltage of 15 VDC and consumes up to 190 mA of current. It is available in a module that measures 1.10 x 1.50 x 0.75 inches and is ideal for radar systems, communication systems and test equipments.
 
Download Datasheet | Product Details
 
Sponsored by Mouser
Mouser Now Stocks Analog Devices HMC8500 GaN RF Amplifiers
Mouser Now Stocks Analog Devices HMC8500 GaN RF Amplifiers
Analog Devices HMC8500 RF Amplifiers are broadband power amplifiers that are constructed with gallium nitride (GaN). The HMC8500 series provides >10W with up to 55% power added efficiency (PAE) and ±1.0dB typical gain flatness across a 0.01GHz to 2.8GHz instantaneous bandwidth. Click here to learn more.
 
 
 
RF Transistor
1400 W GaN Transistor from 960 to 1215 MHz

RF Transistor from Infineon Technologies

The GTVA101K42EV from Infineon is a GaN HEMT that operates from 960 to 1215 MHz. It provides a gain of 17 dB with a drain efficiency of 68%. The transistor delivers an output power of 1400 W while operating on single 50 V supply voltage. It is available in a thermally-enhanced surface-mount package with bolt-down flange.
 
Download Datasheet | Product Details
 
RF Mixer
Wideband I/Q MMIC Mixer from 20 to 42 GHz

RF Mixer from Analog Devices

The HMC8192 from Analog Devices is a passive I/Q MMIC mixer with an RF/LO frequency from 20 to 42 GHz and an IF frequency from DC to 5 GHz. It can either be used as an image reject mixer for receiver operations or as a single sideband upconverter for transmitter operations. This mixer is ideal for applications requiring wide frequency range, excellent RF performance, and a simpler design with fewer parts and a smaller printed circuit board (PCB) footprint.
 
Download Datasheet | Product Details
 
RF Amplifier
5150 To 5925 MHz High-Efficiency 4 W Power Amplifier

RF Amplifier from Skyworks

The SKY66288-11 is a power amplifier that operates from 5150 to 5925 MHz with high gain and linearity. It has been developed for the unlicensed spectrum of LTE-advanced and can be used in small cell base stations, active antenna arrays and for massive MIMO applications. The PA provides up to 4 watts of power and requires a single supply voltage of 5 V.
 
Download Datasheet | Product Details
 
PXI RF Multiplexer
SP6T & SP4T PXI Microwave Multiplexer Modules

PXI RF Multiplexer from Pickering Interfaces

The 40-784A PXI Microwave Multiplexer Modules are available in 6 GHz, 18 GHz, 26.5 GHz and 40 GHz configurations. This series consists of single, dual and triple subminiature SP6T and SP4T Multiplexers. The modules are suitable for constructing complex microwave switching networks and provide a range of switching configurations to suit most applications.
 
Download Datasheet | Product Details
 
About everything RF
everything RF is a product discovery platform for RF & Microwave products/Services. We list over 100,000 Products from more than 200 Companies across 200 Categories in our database and enable engineers to search for them using our customized parametric search tool.