1. everything RF
  2. RF Newsletters
more
PREV 21st Feb, 2018 NEXT

New RF & Microwave Products this Week

21 Feb, 2018 - everything RF Newsletter

RF & Microwave industry updates. View it in your browser

 
everything RF
Date: 21 Feb, 2018
 
Sponsored By Mouser
 
 
 
New RF & Microwave Products this Week
RF Spectrum Recording and Playback System
RF Record and Playback System from 9 kHz to 6 GHz

RF Spectrum Recording and Playback System from Averna

The RP-6500 from Averna is a wideband RF Record and Playback platform that can record 500 MHz of streaming bandwidth from 9 kHz to 6 GHz. The solution is preloaded with RF Studio, a powerful RF record/playback software for capturing real-world RF spectrum, including GNSS, radio, video & location data. With this software, users can easily set up recordings, add contextual data, visualize weak signals, and analyze collected RF environments to validate and fine-tune designs and products.
 
Download Datasheet | Product Details
 
RF Shielded Test Enclosure
Mobile Shielded Test Chamber Provides Isolation up to 87 GHz

RF Shielded Test Enclosure from Rohde & Schwarz

The R&S®ATS1000 is a mobile shielded chamber that has been developed for antenna testing. This test chamber provides a highly shielded environment (greater than 50 dB) over a very wide frequency range from 18 GHz to 87 GHz. The wide frequency range makes it ideal for testing mm-Wave and 5G applications.
 
Download Datasheet | Product Details
 
RF Amplifier
250 Watt CW Amplifier from 80 to 1000 MHz

RF Amplifier from AR RF/Microwave Instrumentation

The 250W1000C from AR RF/Microwave Instrumentation is a 250 watt CW Amplifier that operates from 80 to 1000 MHz. This solid state, self-contained, air-cooled, broadband amplifier is ideal for applications where instantaneous bandwidth, high gain and linearity are required. The amplifier is available in a benchtop cabinet or rack mount module with front panel control options.
 
Download Datasheet | Product Details
 
Band Pass Filter
Passive MMIC Bandpass Filter from 21 to 27 GHz

Band Pass Filter from Marki Microwave

The MFB-2400 from Marki Microwave is a passive GaAs MMIC bandpass filter with a passband from 21 to 27 GHz. The filter has an insertion loss of under 3 dB and more than 25 dB of rejection above and below the passband. It can handle up to 30 dBm of input power. The MFB-2400 is available as a wire bondable chip and is ideal for K-band and SATCOM applications.
 
Download Datasheet | Product Details
 
Frequency Synthesizer
46.875 to 6000 MHz, PLL fractional/integer Frequency Synthesizer

Frequency Synthesizer from STMicroelectronics

The STW81200 is a dual architecture frequency synthesizer (Fractional-N and Integer-N) that generates RF outputs from 46.875 to 6000 MHz. It has three low phase-noise VCOs with a fundamental frequency range of 3.0 GHz to 6.0 GHz and a programmable dual RF output divider stage. The frequency synthesizer is compatible with a wide range of supply voltages from 3.0 V to 5.4 V providing very high level of flexibility.
 
Download Datasheet | Product Details
 
RF Module
802.11ac & 2x2 MU-MIMO Wi-Fi + Bluetooth v4.2 Module

RF Module from Laird Technologies

The 60-2230C from Laird Technologies is a certified 802.11ac 2x2 MU-MIMO Wi-Fi + Bluetooth v4.2 module (Bluetooth 5 ready) that is designed for low-power mobile devices. It is pre-calibrated and integrates the complete transmit/receive RF paths including band pass filter, diplexer, switches, reference crystal oscillator, and power manage units (PMU).
 
Download Datasheet | Product Details
 
Sponsored by Mouser
Digi International XBee 3™ ZigBee 3.0 RF Modules
RF Modules for Wireless Mesh Networks
Digi International XBee3™ ZigBee 3.0 RF Modules provide an IoT end-node for applications that acquire and process data at the end-device and send only actionable data upstream in the network. Digi XBee3 modules are fully integrated, certified and ready to connect to wireless mesh networks. Click here to learn more.
 
 
 
RF Switch
SP7T Absorptive Switch from 2 to 8 GHz

RF Switch from Planar Monolithics Industries

The P7T-2G18G-60-T-1W from PMI RF is a SP7T absorptive switch that operates from 2 to 8 GHz. It has phase and amplitude matching of ±6° and ±0.5 dB respectively. It has a low in-band video leakage of -65 dBm. The switch has an insertion loss of less than 4.5 dB and isolation of over 60 dB. It has a switching speed of less than 100 ns.
 
Download Datasheet | Product Details
 
Antenna
2 Port Sector Antenna from 3300 to 3800 MHz

Antenna from KP Performance Antennas

The KP-3DP65S-45 is a 2 port sector antenna that operates from 3300 to 3800 MHz. It has a 65° HPBW, 3.5° fixed electrical downtilt and provides 17 dBi of gain with a slant dual polarization. This antenna simultaneously maximizes coverage and minimize interference. It is ideal for LTE Applications.
 
Download Datasheet | Product Details
 
Power Divider
0.698-2.7 700 W Low PIM Reactive RF Power Divider

Power Divider from MECA

The LPR2D-1.900-M01WWP is a 2 Way Low PIM Power Splitter that operates from 0.698 to 2.7 GHz. It can handle up to 700 W of power, has an insertion loss of under 0.4 dB and a PIM of -165 dBc. The divider is matched to 50 Ohms, has a VSWR of 1.3:1 and is available with 7/16 or N Type connectors.
 
Download Datasheet | Product Details
 
RF & Microwave Isolator
6 to 12 GHz Coaxial Isolator

RF & Microwave Isolator from VidaRF

The VCI-60120 from VidaRF is a coaxial isolator that operates from 6 to 12 GHz. This isolator provides a port to port isolation of 17 dB with an insertion loss of 0.7 dB. It can handle up to 25 watts of power and is available in a module with SMA connectors.
 
Download Datasheet | Product Details
 
RF Variable Attenuator
6-Bit Digital Step Attenuator from 47 to 2000 MHz

RF Variable Attenuator from Qorvo

The QPC3624 from Qorvo is a 75 ohm, 6-bit digital step attenuator that operates from 47 to 2000 MHz. It has an attenuation range of up to 31.5 dB with 0.5 dB steps and a low insertion loss of 1.3 dB at 1 GHz. The attenuator has three modes of control: serial, latched parallel, and direct parallel programming. Its patented circuit architecture provides overshoot-free transient switching performance.
 
Download Datasheet | Product Details
 
RF Amplifier
Low Noise Amplifier from 18 to 42 GHz

RF Amplifier from SAGE Millimeter

The SBL-1834232840-KFKF-E3 from Sage Millimeter is a low noise amplifier that operates from 18 to 42 GHz. This LNA provides a gain of 28 dB with a noise figure of 4 dB. It requires a +12 VDC supply while drawing 240 mA of current. It is available in a module with K Type - Female connectors at the input and output (other connector options are also available).
 
Download Datasheet | Product Details
 
Sponsored By Mouser
 
 
 
180 Degree Hybrid Coupler
180 Degree/3 dB Hybrid Coupler from 6 to 40 GHz

180 Degree Hybrid Coupler from Pulsar Microwave

The JSO-51-471/6S from Pulsar Microwave is a 180 Degree/3 dB Hybrid Coupler that operates from 6 to 40 GHz. It has an insertion loss of less than 3 dB and isolation over 13 dB with good amplitude and phase balance. The coupler can handle up to 20 watts of power and has a VSWR of 1.90:1. It is available in a module that measures 1.6 x 1.6 x 0.4 inches with 2.92 mm connectors.
 
Download Datasheet | Product Details
 
RF Switch
SPDT Switch with Integrated Dual Directional Coupler from 800 to 3000 MHz

RF Switch from Aethercomm

The SSHPS/C 0.800-3.000-150 from Aethercomm is a symmetrical SPDT RF switch/coupler assembly that operates from 800 to 3000 MHz. This module consists of a SPDT switch with an integrated dual directional coupler to measure forward and reflected power. The switch has an insertion loss of under 2.5 dB, isolation of over 30 dB and a switching speed of 9.8 usec.
 
Download Datasheet | Product Details
 
RF Switch
Reflective SPDT Switch for Wi-Fi, CATV, IoT and 5G Applications

RF Switch from BeRex, Inc.

The BSW7221 from BeRex is a Reflective SPDT Switch that operates from 1 MHz to 6000 MHz. It can be used in either 50 Ohm or 75 Ohm impedance terminated systems. The switch provides an isolation of 43 dB with low insertion loss of 0.49 dB at 2.45 GHz and has a fast switching time of 90 to 135 ns. It is available in a 6-lead, 1.5 x 1.5 mm UDFN package and is ideal for 802.11 Wi-Fi, DOCIS 3.1 CATV, NFC, IoT and 5G Applications.
 
Product Details
 
RF Module
Low Power ZigBee, 802.15.4, DigiMesh and BLE RF Module

RF Module from Digi

The XBee3 ZigBee3.0 modules from Digi support all 2.4 GHz protocols including ZigBee, 802.15.4, DigiMesh and BLE. These modules provide MicroPython programmability and dual-mode radios that are capable of providing RF connectivity for short range and Low Power Wide Area Network (LPWAN) applications.
 
Download Datasheet | Product Details
 
Low Pass Filter
DC to 1207.5 MHz Miniature SMD Low Pass Filter

Low Pass Filter from KR Electronics Inc

The 3337+ from KR Electronics is a low pass filter with a passband from DC to 1207.5 MHz. The filter has an insertion loss of under 2 dB and a rejection of over 18 dB above the passband. It is available in a compact surface mount package that measures 0.20 x 0.30 x 0.181 inches.
 
Download Datasheet | Product Details
 
About everything RF
Our weekly product update newsletter tells you about new RF & Microwave products. Visit the website to learn about new products in each category. Our search tool will help you find the latest products from the leading manufacturers based on your requirement.

To unsubscribe please click here[Sender_Name]
[Sender_Address], [Sender_City], [Sender_State], [Sender_Zip]