PREV 10th April, 2019 NEXT

New RF & Microwave Products this Week

10 April, 2019 - everything RF Newsletter

RF & Microwave industry updates. View it in your browser

 
everything RF
Date: 10 April, 2019
 
Sponsored by SV Microwave
 
 
 
New RF & Microwave Products this Week
RF Transistor
750 W LDMOS Power Transistor for 915 MHz Industrial Applications

RF Transistor from Ampleon

The BLF0910H9LS750P is a LDMOS power transistor that operates from 902 to 928 MHz. It delivers an output power of 750 watts with an efficiency of 72.5%. The transistor is built on Ampleon’s Gen9HV 50 V process, and is ideal for use in industrial, scientific, and medical systems, as well as for professional cooking applications.
 
Download Datasheet | Product Details
 
RF Amplifier
3.5 to 3.7 GHz Hybrid GaN PA Module for 5G Massive MIMO Applications

RF Amplifier from RFHIC

The RTH353705X is a fully matched Doherty GaN hybrid power amplifier module designed for 5G Massive MIMO systems, small cells, and low power remote radio head applications. This 2-stage power amplifier can deliver up to 5 watts of output power while operating from 3500 to 3700 MHz. It provides a gain of 26 dB with an efficiency of 42%.
 
Download Datasheet | Product Details
 
High Pass Filter
High Pass Filters from 27.5 to 40 GHz

High Pass Filter from Wainwright Instruments

The WHW2 series of High Pass Filters have a passband from 27.5 to 40 GHz. The cutoff frequency (Fco) can be customized between 27.5 to 28 GHz. They have an insertion loss of under 0.5 dB and a stopband attenuation of over 40 dB. The HPFs can handle an input power of up to 30 watts. They are available in a surface mount package that measures 60 x 20 x 12 mm (with connectors and flanges) with PC 2.92 male/female connectors.
 
Download Datasheet | Product Details
 
Signal Generator
Handheld Signal Generator from 10 to 18 GHz

Signal Generator from SAF Tehnika

The J0SSAG12 from SAF Tehnika is a Handheld Signal Generator that operates from 10 to 18 GHz. It has a output power range of -3 to 11 dBm. This generator is ideal for carrying out different microwave system analysis and measurement applications LOS Verification, Antenna alignment etc. It has a touch screen intuitive interface that can be used even when wearing gloves. The signal generator is available in a handheld form factor that measures 128 x 81 x 24 mm.
 
Download Datasheet | Product Details
 
RF Spectrum Analyzer
Real-Time Spectrum Analyzer with GNSS Capabilities

RF Spectrum Analyzer from ThinkRF

The R5750 from ThinkRF is a portable Real-Time Spectrum Analyzer with built-in GNSS capabilities for mobile wireless situational awareness applications such as drive testing, coverage mapping, propagation analysis, direction finding & transmitter localization and vehicle-based spectrum monitoring. This analyzer can analyze signals up to 27 GHz with a real-time bandwidth of 100 MHz and has stream rates of 28 GHz/s.
 
Download Datasheet | Product Details
 
RF Amplifier
C & X-Band Low Noise Amplifier from 5 to 10 GHz

RF Amplifier from NuWaves Engineering

The HILNA-CX from NuWaves is a low noise amplifier that operates from 5 to 10 GHz. It delivers a gain of over 35 dB with a noise figure of 2.5 dB and OIP3 of 21 dBm. The amplifier requires a supply of 12 V and consumes up to 170 mA of current.
 
Download Datasheet | Product Details
 
Sponsored by SV Microwave
5G Product Development
Let SV Microwave be Your Partner in 5G Product Development!
SV offers a variety of millimeter wave (mmWave) interconnects for 5G mobile wireless development and production. Our extreme frequency (26 GHz and beyond) threaded RF connectors offer industry leading signal fidelity in the 5G frequency spectrum. Click here to learn more.
 
 
 
RF Amplifier
5 Watt Solid State Power Amplifier from 10 kHz to 1000 MHz

RF Amplifier from AR RF/Microwave Instrumentation

The 5U1000 from AR RF/Microwave Instrumentation is a solid-state, self-contained, air-cooled, broadband amplifier that operates from 10 KHz to 1000 MHz. The amplifier provides an output power of more than 5 watts when used with a sweep generator and a gain of over 37 dB. This amplifier is designed for applications where instantaneous bandwidth, high gain, and linearity are required.
 
Download Datasheet | Product Details
 
RF & Microwave Circulator
50 W Coaxial Circulator from 1.4 to 2.7 GHz

RF & Microwave Circulator from Hytem

The 09.02.62 from Hytem is an RF Circulator that operates from 1.4 to 2.7 GHz. It has an insertion loss of below 0.6 dB and provides an isolation of over 18 dB. The circulator can handle up to 50 watts of CW power and is available in a module with SMA female connectors.
 
Download Datasheet | Product Details
 
RF Switch
GaN Broadband SPDT RF Switch from 30 MHz to 6 GHz

RF Switch from Tagore Technology

The TS7224FK is a GaN SPDT RF Switch that operates from 30 MHz to 6 GHz. It has an insertion loss of 0.35 dB and an isolation of 45 dB @ 800 MHz. This reflective switch can handle an input power of up to 41 dBm while operating from a 2.6 to 5.5 V supply. The TS7224FK is available in a 3 x 3 x 0.8 mm QFN package and is ideal for small cells, satellite terminals, LTE relays and cellular infrastructure applications.
 
Download Datasheet | Product Details
 
Balun
RF Balun from 0.8 to 2.5 GHz

Balun from Innovative Power Products

The IPP-5008 is an RF balun that operates from 0.8 to 2.5 GHz. This 3-port transformer converts between a balanced signal (one signal referenced to ground) and an unbalanced signal (two signals referenced to each other). The balun has an insertion loss of under 0.45 dB and can handle an input power of up to 100 watts. It has been tuned for an optimal amplitude balance of 0.4 dB and phase balance of 8 degrees.
 
Download Datasheet | Product Details
 
Digital Phase Shifter
GaAs MMIC 6-Bit Digital Phase Shifter from 7 to 13 GHz

Digital Phase Shifter from Vectrawave

The VWA 0000948 AA from Vectrawave is a GaAs MMIC 6-Bit digital phase shifter that operates from 7 to 13 GHz. It has an LSB of 5.6 degrees and is controlled by 6 digital binary inputs, compatible with LVCMOS levels. This device uses a single -7.5 V Bias supply voltage. The digital control logic allows for parallel data input, so phase shifter may be changed instantaneously.
 
Download Datasheet | Product Details
 
Limiter
SMT Quasi-Active Limiter Module from 2 to 8 GHz

Limiter from RFuW Engineering

The RFLM-202802QX-290 from RFuW Engineering is a Two Stage Quasi-Active Limiter module that operates from 2 to 8 GHz. This module provides passive receiver protection (always on) against average powers of up to 50 dBm and peak powers of up to 60 dBm pulsed, while maintaining a low flat leakage of less than 17 dBm, and reduced Spike Leakage of less than 0.5 ergs.
 
Download Datasheet | Product Details
 
Sponsored by SV Microwave
Pre-Tinned PCB Connectors
Order SV Microwave’s Pre-Tinned PCB Connectors Today!
SV Microwave’s pre-tinned surface mount and edge launch coaxial PCB connectors provide fast and easy soldering by eliminating a step during installation. These pre-tinned PCB connectors not only prevent rust, corrosion and oxidization, but also increase the durability of the solder joints. Click here to learn more.
 
 
 
90 Degree Hybrid Coupler
90 Degree Hybrid Coupler from 0.7 to 1 GHz

90 Degree Hybrid Coupler from Anaren Inc

The X3C09A2-03S is a low profile, high performance 3 dB hybrid coupler that operates from 0.7 to 1 GHz (AMPS Band). This surface mount coupler can be used for high power applications up to 300 watts. It has been designed for use with balanced power and low noise amplifiers and for other signal distribution applications where low insertion loss and tight amplitude and phase balance is required.
 
Download Datasheet | Product Details
 
Directional Coupler
10/20 dB Directional Couplers from 7 to 12.4 GHz

Directional Coupler from P1dB Inc.

The P1CP-SAF-0712 Series from P1dB are directional couplers that operate from 7 to 12.4 GHz. They have coupling values of 10 & 20 dB and can handle up to 50 watts of average power. These couplers have an insertion loss of under 0.3 dB, directivity of over 17 dB and a VSWR of 1.30:1.
 
Download Datasheet | Product Details
 
Satellite Link Emulator
Satellite Link Emulator from 950 to 1450 MHz

Satellite Link Emulator from Polaris

The PSLE-L-10D from Polaris is a Satellite Link Emulator for geostationary satellites that operates from 950 to 1450 MHz. It is an ideal solution for satellite modem testing, satellite to earth station RF link testing, spacecraft payload testing and in general testing systems using satellite communications.
 
Download Datasheet | Product Details
 
RF Spectrum Recording and Playback System
RF Spectrum Recorder operating from DC to 6 GHz

RF Spectrum Recording and Playback System from Pentek

The Talon RTR 2623 combines Pentek’s Sentinel Intelligent Signal Scanning software with real-time recording in a lightweight, portable and rugged package. The system provides SIGINT engineers the ability to scan the spectrum from DC to 6 GHz for signals of interest and monitor or record bandwidths up to 40 MHz once a signal band of interest is detected.
 
Download Datasheet | Product Details
 
TCXO
10 MHz to 1.5 GHz TCXOs

TCXO from Taitien

The TX-P series from Taitien are Temperature Controlled Crystal Oscillators (TCXOs) that operate from 10 MHz to 1.5 GHz. They require a supply voltage of 2.5 & 3.3 V dc and provide a CMOS, LVDS or LVPECL output. The TCXOs have a low phase jitter of 0.8 pS RMS at 12 kHz to 20 MHz frequency offsets and frequency stability of ±2.0 ppm over a temperature range of -40ºC to 85ºC.
 
Download Datasheet | Product Details
 
Antenna
16 dBi Directional Antenna from 902 to 940 MHz

Antenna from MP Antenna

The 08-ANT-0910 from MP Antenna is a Directional Antenna that operates from 902 to 940 MHz. The Multi-Polarized antenna provides a gain of 16 dBi and can handle an input power of up to 100 watts. This 30 Degree directional antenna is ideal for indoor and outdoor deployments where a sectorized approach is required to accommodate clients in a variety of points.
 
Download Datasheet | Product Details
 
RFID Tag IC
High Capacity EPC Class 1 Gen 2 RFID Tag IC

RFID Tag IC from Alien Technology

The Higgs-9 IC from Alien Technology is an EPC Class 1 Gen 2 RFID Tag IC that operates from 840 to 960 MHz. This chip has a read sensitivity of up to -22.5 dBm and a write sensitivity of up to -19 dBm. Incorporating the Higgs Sentinel™ Memory platform, it provides superior write accuracy, memory retention and read reliability under the most extreme conditions.
 
Download Datasheet | Product Details
 
About everything RF
everything RF keeps users up to date with the RF & Microwave Industry. We provide the latest news, white papers, products, articles, interviews and much more.