1. everything RF
  2. RF Newsletters
more
PREV 15 April, 2020 NEXT

New RF and Microwave Products this Week

15 April, 2020 - everything RF Newsletter

New products this week. View it in your browser

 
Date: 15 April, 2020
 
Sponsored by Anokiwave
 
 
 
New RF and Microwave Products this Week
Front End Module
2x2 MIMO, 5 GHz Front End Module for Wi-Fi 6

Front End Module  from NXP Semiconductors

The WLAN8101C from NXP is a 5 GHz 2 x 2 MIMO Front End Module that supports WLAN IEEE 802.11 a/n/ac/ax and Wi-Fi 6. It includes two monolithic front-end ICs. Each IC has an integrated WLAN amplifier, an integrated Bluetooth amplifier, a low noise amplifier with bypass functionality, directional couplers, and an SPDT switch.
Download Datasheet | Product Details
Front End Module
5 GHz Front-End Module for WLAN Applications

Front End Module  from Skyworks Solutions

The SKY55501-1 from Skyworks is a 5 GHz Front-End Module (FEM) that supports simultaneous 5 GHz WLAN and licensed assisted access (LAA) systems. This highly-integrated module incorporates a 5 GHz low-noise amplifier (LNA) with bypass supporting 5 GHz WLAN and LAA simultaneous RX reception, and an SPDT transmit/receive (T/R) switch.
Download Datasheet | Product Details
Band Pass Filter
2.4 GHz BAW Wi-Fi Filter with Sharp Band Edges

Band Pass Filter  from Qorvo

The QPQ1909 from Qorvo is a Bulk Acoustic Wave (BAW) Band-Pass Filter with extremely steep skirts, simultaneously exhibiting low loss in the Wi-Fi band (Channels 1-14) and high rejection above 2500 MHz and below 2400 MHz. This high-performance, high power filter module has been specifically designed to enable band-edge performance in Wi-Fi applications.
Download Datasheet | Product Details
Vector Network Analyzer
1-Port USB Vector Network Analyzer from 85 MHz to 14 GHz

Vector Network Analyzer  from Copper Mountain Technologies

The R140 VNA is a 1-port USB powered VNA that operates from 85 MHz to 14 GHz. The VNA is the size of a deck of cards and can be controlled by any Windows PC or laptop. The R140 provides a wide variety of analysis capabilities, including time-domain with gating and DTF measurements at no additional cost.
Download Datasheet | Product Details
Antenna
High Precision GPS/GNSS/SBAS/RTK Active Screw Mount Antenna

Antenna  from 2J Antennas

The 2J6901BC2F from 2J Antennas is a GNSS Active Antenna that supports GPS/GLONASS/BeiDou/QZSS/Galileo/RTK services while operating from 1561 to 1606 MHz in the L1 band and at 1227.6 MHz in the L2 band. The antenna delivers an active gain of 28 dB with a noise figure of less than 1.6 dB and requires a supply voltage of 2.3 to 6 V.
Download Datasheet | Product Details
RF Amplifier
60 W L & S-Band Power Amplifier from 960 to 1390 MHz

RF Amplifier  from NuWaves Engineering

The L60T01 from Nuwaves is an L & S-Band Power Amplifier that delivers 60 watts of RF power from 960 to 1390 MHz to extend the operational range of airborne telemetry links and transmitters. It can handle an RF input power of 0 dBm (1 mW) and provides 48 dB of gain for continuous wave (CW) and near-constant-envelope waveforms.
Download Datasheet | Product Details
Sponsored by Anokiwave
Intelligent Array mmW IC Solutions
Intelligent Array mmW IC Solutions
Anokiwave leads the mmW market with its Silicon ICs for 5G, SATCOM, and RADAR applications shipping in high volume commercial deployments. Our portfolio of ICs enables intelligent, scalable antenna arrays that can be configured for different use cases, power levels, and frequency bands. Anokiwave is the trusted choice of Tier-1 and -2 OEMS worldwide. Click here to learn more.
 
Band Pass Filter
3.4 to 3.6 GHz Ceramic Band Pass Filter for 5G Applications

Band Pass Filter  from Anatech Electronics

The AM3500B1093 from Anatech Electronics is a Ceramic Band Pass Filter with a passband from 3400 to 3600 MHz for 5G Applications. It has a passband insertion loss of less than 1.7 dB and can handle an input power of up to 2 watts. The filter has an I/O impedance of 50 ohms and provides an attenuation of 28 dB above and below the passband.
Download Datasheet | Product Details
Frequency Multiplier
U-band Active 4x Frequency Multiplier from 40 to 60 GHz

Frequency Multiplier  from AT Microwave

AT-AM4-4060-18 from AT Microwave is a U-band, Active 4x Frequency Multiplier that converts an input frequency from 10 to 15 GHz to an output frequency from 40 to 60 GHz. It can handle up to 10 dBm of input power and delivers an output power of 18 dBm. This multiplier requires a supply voltage of 5V while consuming 600 mA of current and has a harmonic suppression of -15 dBc.
Download Datasheet | Product Details
Cellular IoT Module
Multi-Band LTE CAT 1 Module for Global Use

Cellular IoT Module  from SIMCom

The SIM7600G from SIMCom is a Multi-Band LTE-FDD/LTE-TDD/HSPA+ and EDGE/GPRS/GSM module which supports LTE CAT1 Globally. It is designed for applications that need high throughput data communication in a variety of radio propagation conditions. The module has uplink data rates of up to 5.76 Mbps and downlink data rates of up to 42 Mbps.
Download Datasheet | Product Details
Power Divider
6 Way, 30 W Power divider from 0.5 to 6 GHz

Power Divider  from MECA

The 806-2-3.250WWP from MECA is a 6-way power divider that operates from 0.5 to 6 GHz covering all ISM and Public Safety bands. It can handle up to 30 watts of power, has an insertion loss of under 3 dB and isolation over 13 dB. The power divider is available in a module with SMA Female connectors.
Download Datasheet | Product Details
Power Divider
30 W, 8-Way Power Divider from 9 to 10 GHz

Power Divider  from Renaissance Electronics Corporation

The 10A8NA-8S-S from Renaissance Electronics is an 8-way Power Divider that operates from 9 to 10 GHz. This X-band splitter has an insertion loss of 0.9 dB, an isolation of 23 dB, and can handle 30 watts of CW power. The device has a phase balance of 1 degree and an amplitude balance of 0.1 dB.
Download Datasheet | Product Details
RF Variable Attenuator
Solid State USB Programmable Attenuator from 20 to 3000 MHz

RF Variable Attenuator  from JFW Industries

The 50P-2055 from JFW Industries is a solid state USB programmable attenuator that operates from 20 MHz to 3000 MHz. It has an attenuation range of 0 to 95 dB, a step size of 0.5 dB and a switching speed of 4 us. The attenuator can handle an input power of up to 27 dBm. It has SMA connectors at the input and output ports which are matched to 50 ohms.
Download Datasheet | Product Details
Sponsored by Anokiwave
 
 
 
RF Amplifier
Low Noise Amplifier IC for GNSS and Satellite Radio Applications

RF Amplifier  from California Eastern Laboratories

The CA3509M4 from CEL is an L to S-Band Low Noise Amplifier IC for GNSS and Satellite Radio Applications that operate at 1.575 GHz. It delivers an output power of 12 dBm with a gain of 17 dB and has a noise figure of 0.4 dB. The amplifier IC is available in a flat-lead 4-pin thin-type super mini mold package with an on-chip ESD protection diode.
Download Datasheet | Product Details
RF Amplifier
600 W Power LDMOS Module from 902 to 928 MHz for ISM Applications

RF Amplifier  from Ampleon

The BPF0910H9X600 from Ampleon is a Power LDMOS Module that operates from 902 to 928 MHz. The device provides 600 watts of CW power with a gain of over 17 dB and a drain efficiency of 69 % while operating from a 50 V supply. It features a built-in temperature sensor and temperature compensation networks. This 50-ohm module measures 92 x 60 mm and is ideal for Heating and ISM Applications.
Download Datasheet | Product Details
Balun
2-Way Balun from 20 to 1000 MHz

Balun  from Innovative Power Products

The IPP-5003 is an RF balun that operates from 20 to 1000 MHz. This 2-way device has an insertion loss of less than 0.5 dB and can handle an input power of up to 100 watts. It has been tuned to have a low amplitude balance of 0.45 dB and a phase balance of 6 degrees. The balun is available in a 1.10 x 1.15 inch SMD package.
Download Datasheet | Product Details
Signal Generator
RF Signal Generator from 50 to 13000 MHz with Ultra-Low Phase Noise

Signal Generator  from DS Instruments

The SG12000PRO from DS Instruments is an RF Signal Generator that operates from 50 MHz to 13 GHz (10 MHz to 15 GHz in uncalibrated mode) with a step size of 10 Hz. It can generate an output power level of up to 10 dBm with a dynamic range of 70 dB. It generates a signal with a low phase noise of -94 dBc @10 kHz. The phase noise of the generated signal is 30 dB lower than the standard SG12000.
Download Datasheet | Product Details
RF Amplifier
GaAs Power Amplifier MMIC from 0.1 to 9 GHz

RF Amplifier  from AMCOM Communications, Inc.

The AM009024WM-QN5-R from Amcom Communications is a GaAs Power Amplifier MMIC that operates from 0.1 to 9 GHz. It provides a P1dB of 24 dBm with a small signal gain of over 18 dB. This RoHS-compliant MMIC is available in a QFN package with both RF and DC leads at the bottom of the package to facilitate low-cost SMT assembly to the PC board.
Download Datasheet | Product Details
Voltage Controlled Oscillator
4800 MHz Voltage Controlled Oscillator with Low Phase Noise

Voltage Controlled Oscillator  from Crystek Corporation

The CVCO55CC-4800-4800 from Crystek Corporation is a Voltage Controlled Oscillator that operates at 4800 MHz. The device has a tuning voltage range from 0.5 to 4.5 VDC and has a tuning sensitivity of 15 MHz/V. It delivers an output power of up to 6 dBm and has a low phase noise of -122 dBc/Hz @100 kHz offset. The VCO is available in an SMD package that measures 0.5 x 0.5 inches.
Download Datasheet | Product Details
Base Station Antenna
Dual Polarized Omni-Directional Antenna from 4.4 to 6.05 GHz

Base Station Antenna  from Mars Antenna & RF System

The MA-WO52-DP7 from Mars Antennas is an Omni-Directional Antenna that operates from 4.4 to 6.05 GHz. This dual-polarized antenna delivers a gain of 7 dBi and can handle an input power of up to 10 watts. It has a port-to-port isolation of 35 dB and a VSWR of less than 2.5:1. The antenna measures 420 (H) x 66 (D) mm and is available with N-type female connectors.
Download Datasheet | Product Details
About everything RF
everything RF keeps users up to date with the RF & Microwave Industry. We provide the latest news stories, information on new product releases, upcoming events, articles, white papers, interviews and much more.
To unsubscribe please click here[Sender_Name]
[Sender_Address], [Sender_City], [Sender_State], [Sender_Zip]