| New RF and Microwave Products this Week . |
|
|
| GaN Transceiver Module from 8.8 to 9.4 GHz for Radar Applications | |
RF Transceiver
from RFHIC
|
| The RRM8894010-M1D from RFHIC is a Transceiver Module that operates from 8.8 to 9.4 GHz. In Tx mode, it uses GaN technology to provide an output power of 10 W (pulse width 100 µs (max.), duty cycle up to 20%) and has harmonics of -30 dBc. In Rx mode, it provides a gain of more than 31 dB with a noise figure of less than 4 dB and includes a limiter for receiver protection. |
| |
Download Datasheet
Product Details | |
|
|
|
| 35 W GaN Power Amplifier MMIC from 15.4 to 17.7 GHz | |
RF Amplifier
from Qorvo
|
| The QPA1315 from Qorvo is a Power Amplifier MMIC that operates from 15.4 to 17.7 GHz. It delivers a saturated output power of 45 dBm (35 W) with a large signal gain of 25 dB and a power-added efficiency of 20%. This amplifier is fabricated on Qorvo's production 0.15 um GaN on SiC process (QGaN15) and has a Cu base for superior thermal management. |
| |
Download Datasheet
Product Details | |
|
|
|
| Spectrum Analyzer from 1 Hz to 4.4 GHz for Lab Use | |
RF Spectrum Analyzer
from Signal Hound
|
| The USB-SA44B from Signal Hound is a Software Defined Radio (SDR) optimized RF Spectrum Analyzer that operates up to 4.4 GHz. It has a wide dynamic range from -151 to 10 dBm with a resolution bandwidth from 0.1 Hz to 250 kHz and 5 MHz. It is a compact, easy to use spectrum analyzer for use in the lab, by ham radio enthusiasts, and electronics hobbyists. |
| |
Download Datasheet
Product Details | |
|
|
|
| Compact USB VNA from 9 kHz to 8.5 GHz | |
Vector Network Analyzer
from Copper Mountain Technologies
|
| The S5085 is a 2-Port Vector Network Analyzer from Copper Mountain Technologies that operates from 9 KHz to 8.5 GHz. It can measure all four S parameters S11, S12, S21, S22 and provides a wide variety of analysis capabilities, including time-domain with gating and frequency offset modes. This lab-grade VNA is available in a compact package and can be controlled with a Windows or Linux-based PC, laptop, tablet, or x86 board computer connected to the measurement hardware via a USB interface. |
| |
Download Datasheet
Product Details | |
|
|
|
| High-Speed EMI Test Receiver from 1 Hz to 44 GHz | |
EMI Receiver
from Rohde & Schwarz
|
| The R&S®ESW44 from Rohde & Schwarz is an EMI Test Receiver that operates from 1 Hz to 44 GHz. It meets the most stringent requirements in line with CISPR, EN, MIL-STD-461, DO-160, and FCC standards. This test receiver includes a low-noise and built-in preselection with 21 filters to enable accurate and reliable measurements for EMI compliance testing. |
| |
Download Datasheet
Product Details | |
|
|
|
| Miniature Programmable Transceiver from 400 MHz to 16 GHz | |
Software Defined Radio
from Cubic Nuvotronics, Inc.
|
| The Multiband Miniature Transceiver (MMT) from Cubic operates in the UHF, L, S, C, and Ku bands from 400 MHz to 16 GHz. It provides the basis for the two-way transport of video and IP data between airborne platforms and land or maritime users. This radio supports programmable waveforms and has been tested for interoperability with U.S. standard CDL and bandwidth-efficient CDL waveforms. |
| |
Download Datasheet
Product Details | |
|
|
| Sponsored by Advanced Test Equipment Corporation | | | |
|
|
| 5G Open-Radio Unit for O-RAN Deployments | |
RAN Radio Unit
from AmpliTech
|
| The A1001-RU-1 from AmpliTech is a 5G Open-Radio Unit (O-RU) for n78 band from 3.55 to 3.7 GHz. It utilizes GaN power amplifiers along with 64 phased array elements for digital beamforming. This O-RU unit is available in a surface-mount package and is suitable for use in high & low-speed networks, IoT deployment, 5G backhaul deployment, and small cell deployment applications. |
| |
Download Datasheet
Product Details | |
|
|
|
| Real-Time & Continuous Spectrum Intelligence Platform | |
RF Spectrum Analyzer
from thinkRF
|
| The Spectrum eXperience Management (SXM) System from thinkRF is a real-time wireless infrastructure monitoring / intelligence platform. It provides continuous monitoring of all major 4G and 5G parameters with immediate notification of any new, changed or discontinued deployments in an area. SXM comprises of powerful thinkRF sensors to collect RF spectrum data, a cloud to store data with maximum cybersecurity and an insightful software (SXM API) that provides advanced analytics to users. |
| |
Download Datasheet
Product Details | |
|
|
|
| Drawn-Seamless EMI/RFI Shields for High-Frequency Applications | |
Board Level EMI/RFI Shielding Can
from Masach Tech
|
| The MS108-10 Series from Masach are Drawn-Seamless EMI/RFI Shields that are designed to meet the electronic industries' high frequency printed circuits and RF applications. They are available in 1 or 2-piece configurations made with tin-plated steel or nickel-silver material. The Nickel-Silver series has high corrosion resistance and is used in sensitive-harsh environments in a variety of industries such as medical devices, aerospace, automotive, etc. |
| |
Download Datasheet
Product Details | |
|
|
|
|
|
|
|
|
|
|
|
|
|
| Precision Waveguide AWGN Noise Sources from 18 to 110 GHz | |
Noise Source
from Noisecom
|
| The NC5000A Series from Noisecom are AWGN Noise Sources for frequency ranges from 18 to 110 GHz. They feature outstanding stability, fast switching speeds, and have a ripple-free response over standard waveguide bands. These noise sources support calibration in 1 GHz steps, have a noise output rise/fall time of less than 1 µs and a noise output variation (with temperature) of better than 0.01 dB/°C. |
| |
Download Datasheet
Product Details | |
|
|
| Sponsored by Advanced Test Equipment Corporation | | |
|
|
| 20 W Rackmount Solid-State Power Amplifier from 2 to 18 GHz | |
RF Amplifier
from Talent Microwave Inc
|
| The THPA2G18G-43-43-AC from Talent Microwave is a Solid-State Power Amplifier (SSPA) that operates from 2 to 18 GHz. It delivers a saturated output power of 43 dBm (~20 W) with a power gain of 43 dB. This SSPA has non-harmonic spurious emissions of -60 dBc and harmonics of -10 dBc. It is input/output matched to 50 ohms and includes over TEM, over-voltage, and over-current protection. |
| |
Download Datasheet
Product Details | |
|
|
|
| SP65T Absorptive PIN Diode Switch from 0.1 to 4 GHz | |
RF Switch
from American Microwave Corporation
|
| The MSN-65DT-051-DEC-MP from American Microwave Corporation is an SP65T Absorptive PIN Diode Switch that operates from 100 MHz to 4 GHz. It has an ON/OFF switching time of less than 150 ns, a rise/fall time of 50 ns, and provides isolation of more than 45 dB. This switch can handle a CW input power of up to +20 dBm and has an insertion loss of less than 15 dB. |
| |
Download Datasheet
Product Details | |
|
|
|
| 10-Bit Programmable PIN Diode Attenuator from 32 to 37 GHz | |
RF Variable Attenuator
from Quantic PMI (Planar Monolithics)
|
| The DTA-26R5G40G-30-CD-1-OPT32G37G from PMI is a 10-Bit programmable PIN diode attenuator that operates from 32 to 37 GHz. It has an attenuation range of 30 dB with a step resolution of 0.03 dB. This attenuator provides ultra-fast switching speeds of 300 ns and can handle an input power of upto 10 dBm. It operates from a single 15 VDC supply and draws only 50 mA of current. |
| |
Download Datasheet
Product Details | |
|
|
|
|
|
|
|
|
|
|
|
|
|
| 90° Hybrid Coupler from 150 to 520 MHz | |
90 Degree Hybrid Coupler
from MECA
|
| The 705S-0.335 from MECA is a 90° Hybrid Coupler that operates from 150 to 520 MHz. It provides more than 25 dB of isolation and has a frequency sensitivity of ±1.20 dB. This hybrid coupler can handle an average input power of 50 W and a peak input power of 3000 W. It is available in a module with passivated, stainless steel SMA (female) connectors. |
| |
Download Datasheet
Product Details | |
|
|
|
| Upconverter and Downconverter for 5G Radios from 24 to 29.5 GHz | |
RF Up-down Converter
from Analog Devices
|
| The ADMV1128A from Analog Devices is a Microwave Upconverter and Downconverter that is designed for 5G radios from 24 to 29.5 GHz. It has an integrated upconverter (a transmitter), a downconverter (a receiver), and a LO chain with options of a 2x or 4x multiplier in one chip. Both upconverters and downconverters offer two modes of frequency translation. |
| |
Download Datasheet
Product Details | |
|
|
|
| Multi-Constellation GNSS Module with Jamming Rejection | |
GNSS Module
from Telit Communications
|
| The SE868K5-I from Telit Cinterion is a Multi-Constellation, Multi-Frequency GNSS Module. It has 75 physical acquisition and tracking channels and supports A-GNSS with Ephemeris file injection as well as onboard Ephemeris prediction (A-GPS). This module has EGNOS, WAAS, GAGAN, and MSAS capabilities embedded with correction of positional error correction for augmented accuracy and integrity. |
| |
Download Datasheet
Product Details | |
|
|
|
| Two-Stage Variable-Gain Low Noise Amplifier from 2.3 to 6 GHz | |
RF Amplifier
from Guerrilla RF
|
| The GRF2176 from Guerrilla RF is a Two-Stage Low Noise Amplifier that operates from 2.3 to 6 GHz. It provides a selectable gain of 15.8 dB (low gain mode) and 32.4 dB (high gain mode) with a noise figure of 0.65 dB. This LNA is based on GaAs pHEMT technology and allows the second stage to be bypassed with an independent control pin to select low/high gain modes. |
| |
Download Datasheet
Product Details | |
|
|
|
| 38 dBm Surface-Mount Power Limiter from 2 to 20 GHz | |
Limiter
from MACOM
|
| The MADL-011100 from MACOM is a Power Limiter that operates from 2 to 20 GHz. It can handle up to 38 dBm of input power (CW), 58 dBm of peak input power (at 13 GHz), and has a flat leakage power of 28 dBm. The limiter has an insertion loss of less than 2.1 dB, a return loss of 15 dB, and a recovery time of 270 ns. |
| |
Download Datasheet
Product Details | |
|
|
|
| Military-Grade SAW Bandpass Filter with Passband from 902 to 928 MHz | |
Band Pass Filter
from Southwest Antennas
|
| The 1080-210 from Southwest Antennas is a Standalone SAW Bandpass Filter with a passband from 902 to 928 MHz. It has a passband insertion loss of less than 3.5 dB and provides out-of-band rejection of -40 dBc (at 880 MHz). This filter has been designed to be installed in-line into a system when additional RF filtering is required to improve the system performance and is suitable for operation in congested, high-interference RF environments. |
| |
Download Datasheet
Product Details | |
|
|
|
| 12-Port Base Station Antenna from 698 to 2690 MHz | |
Base Station Antenna
from Amphenol Antenna Solutions
|
| The 5798400R-C from Amphenol Antenna Solutions is a 12-Port Base Station Antenna that operates from 698 – 960 MHz, 1427 – 2180 MHz, and 2490 – 2690 MHz. It provides a gain of 15.5 dBi and has a VSWR of less than 1.5:1. This cross-polarized antenna has an azimuth beamwidth of 65°, an elevation beamwidth of up to 11.5° and allows an electrical down-tilt from 2° to 12°. |
| |
Download Datasheet
Product Details | |
|
|
|
|
|
|
|
|
|
|
|
