| Featured Products this Week . |
|
|
| Quadrature Hybrid Coupler from 4 to 8 GHz | |
90 Degree Hybrid Coupler
from Knowles
|
| The FHC09096 from Knowles Corporation is a Quadrature Hybrid Coupler that operates from 4 to 8 GHz. This 3dB coupler has an isolation of more than 17.5 dB and an insertion loss of less than 1 dB. It can handle an input power (CW) of 50 W and has a return loss of 17.5 dB. This coupler provides an amplitude balance of ±1 dB and a phase balance of ±3°. |
| |
Download Datasheet
Product Details | |
|
|
|
| Broadband Pick-off Tee from DC to 67 GHz | |
Pick off Tee
from HYPERLABS
|
| The HL9467 from Hyperlabs is a Broadband Pick-off Tee that operates from DC to 67 GHz on the thru line and has a 55 GHz bandwidth (-3 dB) on the pick-off line. It is suitable as a trigger source with minimum perturbation of the thru signal path. The Pick-off tee has a thru insertion loss of 4 dB, a pick-off insertion loss of 10 dB, and can handle an input power of up to 30 dBm. |
| |
Download Datasheet
Product Details | |
|
|
|
|
|
|
|
|
| Active GaAs Frequency Doubler/Amplifier from 20 to 50 GHz | |
Frequency Multiplier
from Marki Microwave
|
| The IADA-2050CH from Marki Microwave is an Active GaAs Frequency Doubler/Amplifier that converts input frequencies from 10-25 GHz to output frequencies from 20-50 GHz. This active doubler also acts as an amplifier that delivers an output power of +18 dBm (input power of +5 dBm). It is fabricated based on GaAs Schottky diode technology. |
| |
Download Datasheet
Product Details | |
|
|
|
| 10 dB Directional Coupler from 18 to 40 GHz | |
Directional Coupler
from MECA
|
| The 765-10-29.000 from MECA is a 5G ready millimeter-wave coupler that operates from 18 to 40 GHz. Available with a coupling value of 10 dB, this coupler has an insertion loss of 1.3 dB and directivity of over 12 dB. It can handle an average power of up to 20 watts and has a VSWR of 1.80:1. The 765-10-29.000 is available in a module with 2.92mm female connectors. |
| |
Download Datasheet
Product Details | |
|
|
|
| 80 W GaN-on-SiC Power Amplifier Pallet from 2000 to 6000 MHz | |
RF Amplifier
from RFHIC
|
| The RWP2060080-49 from RFHIC is a GaN-on-SiC Power Amplifier Pallet that operates from 2000 to 6000 MHz. It provides an output power of 80 W (~49 dBm) with a power gain of 49 dB and a power added efficiency (PAE) of 22%. This amplifier is fabricated using GaN-on-SiC technology and is mounted on an aluminum sub-carrier with full in/out matching for broadband operation. |
| |
Download Datasheet
Product Details | |
|
|
| Sponsored by MPG Solutions | | |
|
|
|
|
|
|
|
| Fixed Attenuators from DC to 18 GHz (0 to 20 dB Attenuation) | |
Fixed Attenuator
from Inmet by Spectrum Control
|
| The PCAAW Series of fixed chip attenuators that are available with attenuation configurations from 0 to 20 dB. These attenuators consist of a laser trimmed distributed thin film element on an alumina ceramic substrate with a protective paint layer and solderable leads. They have an attenuation accuracy of 0.5 to 1 dB, can handle up to 4 Watts of power and have a VSWR under 1.5:1. |
| |
Download Datasheet
Product Details | |
|
|
|
| 600 Degree Analog Phase Shifter from 6 to 15 GHz | |
Analog Phase Shifter
from Analog Devices
|
| The HMC-C010 from Analog Devices is a 600 Degree Analog Phase Shifter that operates from 6 to 15 GHz. It provides a constant insertion loss vs phase shift through the frequency band. It has a control voltage from 0-5 V with a phase voltage sensitivity of 120 deg/volt and a modulation bandwidth of 50 MHz. |
| |
Download Datasheet
Product Details | |
|
|
|
|
|
|
|
|
| 61 W Doherty Power Amplifier from 3300 to 3700 MHz | |
RF Amplifier
from NXP Semiconductors
|
| The A3M34SL039 from NXP Semiconductors is a Doherty Power Amplifier that operates from 3300 to 3700 MHz. This LDMOS power amplifier is designed for TDD LTE and 5G systems and has an Autobias feature that allows overwriting production settings and automatically sets and regulates transistor bias over temperature upon power up. |
| |
Download Datasheet
Product Details | |
|
|
|
| Quad-Core Bluetooth 5.4 LE Modules with Global Certification | |
RF Module
from u-blox AG
|
| The ALMA-B1 Series from u-blox are Standalone Multicore Bluetooth Low Energy 5.4 Modules. They offer excellent processing power, efficiency, and receiver sensitivity in a small form factor with support for Thread, Matter, and NFC protocols. These modules are powered by Nordic Semiconductor’s 4th generation nRF54H20 SoC with a quad-core microcontroller unit (MCU) up to 320 MHz. |
| |
Download Datasheet
Product Details | |
|
|
|
|
|
|
|
|
| SP4T Reflective SOI Switch from 9 kHz to 30 GHz | |
RF Switch
from pSemi, A Murata Company
|
| The PE42548 from pSemi is an UltraCMOS SP4T Reflective Switch that operates from 9 kHz to 30 GHz. It has a switching speed of 60 ns, an insertion loss of less than 2.3 dB, and an isolation of more than 33 dB. This broadband switch can handle an input power of up to 29 dBm (~0.8 W) and has a P1dB power of 32 dBm. |
| |
Download Datasheet
Product Details | |
|
|
|
| 180 Degree Hybrid Coupler from 4 to 20 GHz | |
180 Degree Hybrid Coupler
from Pulsar Microwave
|
| The JSO-05-471/1S from Pulsar Microwave is a 180 Degree Hybrid Coupler that operates from 4 to 20 GHz. It has an insertion loss of less than 1.4 dB and isolation over 15 dB with good amplitude and phase balance. The coupler can handle up to 20 watts of power and has a VSWR of 1.70:1. It is available in a module that measures 2.5 x 1.55 x 0.4 inches with SMA connectors. |
| |
Download Datasheet
Product Details | |
|
|
|
| Temperature Compensated VCXO’s from 30 MHz to 2000 MHz | |
TCVCXO
from NEL Frequency Controls
|
| The OK-XBFXXXX Series are temperature compensated, voltage controlled crystal oscillators (TCVCXO) that operate from 30 to 2000 MHz. These SMD oscillators provide excellent temperature stability with a duty cycle of 55%. They can provide CMOS, Sine-Wave, Differential PECL or LVDS outputs with very low phase noise and jitter. |
| |
Download Datasheet
Product Details | |
|
|
|
| 4-Channel Software-Defined Radio from DC to 40 GHz | |
Software Defined Radio
from Per Vices
|
| The Calamine from Per Vices is a 4-Channel Software-Defined Radio (SDR) that operates from DC to 40 GHz. This SDR integrates four receive chains and each chain is integrated with a Texas Instruments dual-channel ADC16DX370 ADC, an RF front-end, and a microcontroller, power board, digital board, and timing block. |
| |
Download Datasheet
Product Details | |
|
|
|
| Omnidirectional Flexible Planar Dipole Antenna from 863 to 928 MHz | |
Antenna
from Ezurio
|
| The FlexDIPOLE from Laird Connectivity is a Flexible Planar Dipole Antenna that operates from 863 to 870 MHz and 902 to 928 MHz. This linear polarized antenna has an omnidirectional radiation pattern with a peak gain of 2.4 dBi and a VSWR of less than 3.0:1. It has an innovative design for mounting featuring adhesive backing, allowing for easy and flexible installation in a variety of enclosures and end product designs. |
| |
Download Datasheet
Product Details | |
|
|
|
| 1 to 40 GHz PLDRO with External Frequency Reference | |
PLDRO
from Exodus Dynamics
|
| The EDPLO-4000 series from Exodus Dynamics is a PLDRO that can be customized to generate a stable frequency signal from 1 to 40 GHz. To do so the PLDRO requires an external reference of 5 or 10 MHz. Once the frequency of the device has been set by the factory, it can further be tuned by 100 MHz mechanically. |
| |
Download Datasheet
Product Details | |
|
|
|
| Gain Equalizer from 0.01 to 20 GHz for Aerospace Applications | |
Gain Equalizer
from ERZIA
|
| The ERZ-EQU-0000-2000-10 from ERZIA is a Gain Equalizer that operates from 0.01 to 20 GHz. It has a positive gain slope over the frequency range and reduces losses for amplifiers and other RF systems. The equalizer has an insertion loss from 2 to 10 dB across the band with a VSWR of 1.5:1. The ERZ-EQU-0000-2000-10 is available in a compact aluminum housing that measures 24 x 18 x 10 mm and has 2.92 mm (female) connectors. |
| |
Download Datasheet
Product Details | |
|
|
|
| SATCOM Antenna from 17.7 to 31 GHz with Anti-Jam Capabilities | |
SATCOM Antenna
from ThinKom
|
| The ThinAir GT 1717 from ThinKom is a SATCOM Antenna that operates from 17.7 to 21.2 GHz (Rx) and 27.5 to 31 GHz (Tx). It has been developed to operate on commercial and government networks, including LEO, MEO, GEO, and HEO constellations. This antenna ensures a low probability of intercept/detection and features inherent anti-jam robustness to operate in demanding EMI, EMC, and EMP environments. |
| |
Download Datasheet
Product Details | |
|
|
|
| Microwave Signal Sources from 3 to 67 GHz | |
Signal Generator
from Saluki Technology
|
| The SFS-Pro Series from Saluki Technology are Microwave Signal Generators with a frequency range from 3 to 67 GHz. They exhibit very low phase noise to achieve excellent signal generation in applications requiring ultra-low phase noise, large dynamic and stable output power, and multi-channel synchronization. |
| |
Download Datasheet
Product Details | |
|
|
|
| High-Speed EMI Test Receiver from 1 Hz to 44 GHz | |
EMI Receiver
from Rohde & Schwarz
|
| The R&S®ESW44 from Rohde & Schwarz is an EMI Test Receiver that operates from 1 Hz to 44 GHz. It meets the most stringent requirements in line with CISPR, EN, MIL-STD-461, DO-160, and FCC standards. This test receiver includes a low-noise and built-in preselection with 21 filters to enable accurate and reliable measurements for EMI compliance testing. |
| |
Download Datasheet
Product Details | |
|
|
|
| Active GPS/BeiDou/GLONASS Timing Antenna from 1559 to 1607 MHz | |
GPS/GNSS Antenna
from PolyPhaser
|
| The PPANGPS1016 from PolyPhaser is an Active GPS/GNSS Timing Antenna that operates from 1559 to 1607 MHz. This right-hand circular polarized (RHCP) antenna filters and amplifies GNSS L1, GLONASS G1, and BeiDou B1 global positioning signals received from satellite constellations. It has an integrated low-noise amplifier (LNA) that provides a gain of 31 dBi with a noise figure of 1.5 dB. |
| |
Download Datasheet
Product Details | |
|
|
|
|
|
|
|
|
| 3GPP Rel-17 5G RedCap Modules with Integrated L1+L5 Band GNSS | |
Cellular Module
from Quectel
|
| The RG255C Series from Quectel are 5G RedCap Modules based on 3GPP Release 17 RedCap technology. They support 5G standalone (SA) modes and are backward-compatible with the 4G network. These modules support a theoretical peak data rate of 150 Mbps (downlink) and 50 Mbps (uplink), while also supporting advanced 5G features such as URLLC and power saving. |
| |
Download Datasheet
Product Details | |
|
|
|
| IP65-Rated 3.5/5 GHz Ethernet-Powered Wireless Radio Link | |
Microwave Backhaul Radio Links
from BLiNQ Networks
|
| The FWC-133-3550 from Blinq Networks is a Category 12/13 Dual-Band Outdoor Customer Premise Equipment (CPE). It has been designed to provide connectivity to base stations in the 3.5/5 GHz bands and supports TDD-LTE bands 48, 42/43, and 46. This 3GPP Release 12-compliant radio has a built-in high gain directional antenna that allows expansion of the LTE signal coverage and an RF front-end with 2 transmitter and 4 receiver channels. |
| |
Download Datasheet
Product Details | |
|
