| New Aerospace & Defense Products . |
|
|
| Microwave Spectrum Monitor Module from 9 kHz to 54 GHz | |
RF Spectrum Analyzer
from Anritsu
|
| The MS27200A from Anritsu is a Microwave Spectrum Monitor Module that operates from 9 kHz to 9/14/20/26.5/32/43.5/54 GHz. It uses the latest technologies to deliver accuracy and precision in measurements previously reserved only for benchtop instruments. This module consists of a real-time spectrum analyzer (RTSA) that has a measurement bandwidth of 110 MHz for capturing transient and continuous signals over a large bandwidth. |
| |
Download Datasheet
Product Details | |
|
|
|
| Multi-Die Dual-Channel Front End Module from 8 to 12 GHz | |
Front End Module
from Qorvo
|
| The QPF5001 from Qorvo is a Multi-Die Dual-Channel Front End Module that operates from 8 to 12 GHz. This FEM integrates a limiter, low noise amplifier (LNA), and a power amplifier (PA). It delivers up to 12 W of transmit saturated output power and has a noise figure of 1.5 dB on the Rx side. The QPF5001 is configured to interface with a circulator and requires a DC supply of 1.5 V (Rx). |
| |
Download Datasheet
Product Details | |
|
|
|
| 10 W SPDT Reflective Switch from 1 to 20 GHz | |
RF Switch
from Analog Devices
|
| The ADRF5144 from Analog Devices is an SPDT Reflective Switch that operates from 1 to 20 GHz. It can handle an average input power of 10 W (~40 dBm), a peak input power of 44 dBm, and has an insertion loss of less than 1.1 dB. This switch has a rise/fall time of 135 ns, an ON/OFF time of 500 ns, and an RF settling time of less than 750 ns. |
| |
Download Datasheet
Product Details | |
|
|
|
|
|
|
|
|
| 3U OpenVPX Multi-Channel Programmable Digital Transceiver | |
RF Transceiver
from Mercury Systems
|
| The EnsembleSeries™ DCM3220 from Mercury Systems is a Multi-Channel Programmable Digital Transceiver optimized for SWaP-constrained environments. It consists of FPGA processing (Virtex Ultrascale VU7P FPGA, Zynq Ultrascale ZU11EG MPSoC, and 7488 DSP slices), VITA 65 backplane, 12-bit ADC and DAC, VITA 67 configurable rear I/O, security engine, and an AS9100D-qualified IPMI controller. |
| |
Download Datasheet
Product Details | |
|
|
|
| 4-Channel Software-Defined Radio Payload from 20 MHz to 6 GHz | |
Software Defined Radio
from Epiq Solutions
|
| The NDR325 from Epiq Solutions is a 4-Channel Software-Defined Radio (SDR) Payload that operates from 20 MHz to 6 GHz. It has a 4-channel, super-heterodyne tuner, with each channel providing 500 MHz of instantaneous bandwidth. This radio unit has both independent and phase coherent tuning to support applications such as search, survey, direction finding, and geolocation. |
| |
Download Datasheet
Product Details | |
|
|
| Sponsored by Global MilSatCom 2024 | | |
|
|
|
|
|
|
|
| Common Data Link for Airborne, Surface, and Maritime Applications | |
Data Link
from BAE Systems
|
| The iCDL from BAE Systems is a Common Data Link that operates in the Ku-Band from 14.4 to 15.35 GHz. It provides the warfighter a complete affordable solution to bring wideband wireless data link capability to airborne, surface, and maritime platforms. This data link has a programmable hardware and software radio design architecture to provide a comprehensive solution. |
| |
Download Datasheet
Product Details | |
|
|
|
|
|
|
|
|
| 60 W, K/Ka-Band TWT Amplifier from 18 to 40 GHz | |
RF Amplifier
from dB Control
|
| The dB-4051 from dB Control is a K/Ka-Band TWT Amplifier that operates from 18 to 40 GHz. It delivers an output power of 50 to 60 W with a gain of over 48 dB and a gain flatness of ±3 dB. This amplifier is a periodic permanent magnet (PPM)-focused, conduction-cooled TWT amplifier that can amplify CW, AM, FM, or pulse-modulated signals. |
| |
Download Datasheet
Product Details | |
|
|
|
| 9.18 GHz Combline Bandpass Filter | |
Band Pass Filter
from Quantic PMI (Planar Monolithics)
|
| The 5CL9D18G-180-CD-SFF from Quantic PMI is a Combline Band Pass Filter with a passband from 9.09 to 9.27 GHz. It has a passband insertion loss of less than 4.0 dB and provides more than 70 dBc of rejection below and 60 dBc of rejection above the passband. This BPF has a loss ripple of 0.5 dB and phase linearity of less than +/- 6º. |
| |
Download Datasheet
Product Details | |
|
|
|
| 50 W RF Termination from DC to 6 GHz | |
Termination
from MECA
|
| The 480-8 from MECA is an RF Termination that operates from DC to 6 GHz. It can handle an average power of 50 W, a peak power of 5 kW, and has a VSWR of 1.20:1. This 50-ohm termination is available in a connectorized module that measures 4.57(L) x 1.62 (Dia.) inches with SMA-female connector. |
| |
Download Datasheet
Product Details | |
|
|
|
|
|
|
|
|
| GaAs pHEMT Low Noise Amplifier from 17 to 55 GHz | |
RF Amplifier
from MACOM
|
| The MAAL-011229 from MACOM is a Low Noise Amplifier that operates from 17 to 55 GHz. It delivers 24 dB of small signal gain with a noise figure of 3.2 dB and a saturated output power of 24 dBm. This amplifier has a gain flatness of ±2 dB and a return loss of 12 dB (input/output). It is fabricated using a GaAs pHEMT process which features full passivation for enhanced reliability and can be used as a low noise amplifier stage or a driver stage in higher power. |
| |
Download Datasheet
Product Details | |
|
|
|
| GaAs Low Noise Amplifier from 0.03 to 3.0 GHz | |
RF Amplifier
from Teledyne e2v HiRel Electronics
|
| The TDLNA0430EP from Teledyne e2v HiRel Electronics is a GaAs Low Noise Amplifier that operates from 0.03 to 3.0 GHz. It delivers a gain of 21.5 dB and has a noise figure of 0.35 dB with an output P1dB of 12 dBm. With simple input and output matching, this LNA can be tuned for different frequency bands targeting LTE (small cells and infrastructure) and many other applications requiring low noise, high gain, and linearity. |
| |
Download Datasheet
Product Details | |
|
|
|
| Gain Equalizer from 0.01 to 20 GHz for Aerospace Applications | |
Gain Equalizer
from ERZIA
|
| The ERZ-EQU-0000-2000-10 from ERZIA is a Gain Equalizer that operates from 0.01 to 20 GHz. It has a positive gain slope over the frequency range and reduces losses for amplifiers and other RF systems. The equalizer has an insertion loss from 2 to 10 dB across the band with a VSWR of 1.5:1. The ERZ-EQU-0000-2000-10 is available in a compact aluminum housing that measures 24 x 18 x 10 mm and has 2.92 mm (female) connectors. |
| |
Download Datasheet
Product Details | |
|
|
|
| Real-time Spectrum Analyzer from 100 kHz to 43.5 GHz | |
RF Spectrum Analyzer
from Signal Hound
|
| The SM435C from Signal Hound is a Real-time Spectrum Analyzer that operates from 100 kHz to 43.5 GHz. It has a dynamic range of 110 dB, a sweep speed of 1 THz/sec at 30kHz RBW (using Nuttall windowing), and an SSB phase noise of -138 dBc/Hz@100 kHz offset. This RTSA is designed for remotely located accurate RF data analysis at the lowest cost possible and includes a 10 Gigabit Ethernet SFP+ port, enabling it to communicate with a PC over long distances using a fiber optic cable. |
| |
Download Datasheet
Product Details | |
|
|
|
| 20 dB Surface Mount Directional Coupler from 8 to 12 GHz | |
Directional Coupler
from TTM Technologies
|
| The XMC0812F1-20G from TTM Technologies is a Directional Coupler that operates from 8 to 12 GHz. This 20 dB coupler has a directivity of more than 20 dB and an insertion loss of less than 0.50 dB. It can handle an average power of 50 W with a VSWR of 1.22:1 and a peak to average ratio of 12 dB. It is available in a surface mount package that measures 0.2 x 0.125 x 0.24 inches and has operating range of temperature between -55 to 150 Degree C. |
| |
Download Datasheet
Product Details | |
|
