PREV 1 June, 2016 NEXT

New RF & Microwave Products this Week

June 1, 2016 - everything RF Newsletter
 
everything RF
Date: June 1, 2016
 
Sponsored by Coilcraft
 
 
 
New RF & Microwave Products this Week
RF Spectrum Analyzer
40 GHz RF Spectrum Analyzer with 160 MHz Analysis Bandwidth

RF Spectrum Analyzer from Rohde & Schwarz

The FSVA series from Rohde & Schwarz are RF Spectrum/Signal Analyzers that are available in five models from 10 Hz to 4 GHz, 7 GHz, 13.6 GHz, 30 GHz and 40 GHz. This series of analyzers has a 160 MHz analysis bandwidth even at 40 GHz.
 
Download Datasheet | Product Details
 
Transceiver
Highly Integrated Silicon Quad Core IC for 5G Phase Arrays

Transceiver from Anokiwave

The AWMF-0108 from Anokiwave is a highly integrated silicon quad core IC for 5G phase array applications. It operates from 27.5 GHz to 30 GHz and supports four Tx/Rx radiating elements that includes all requisite beam steering controls for 5 bit phase and gain control, and operates in half duplex fashion to enable a single antenna to support both Tx and Rx operation.
 
Download Datasheet | Product Details
 
RF Amplifier
0.4 to 6 GHz Low Noise Amplifier for Wireless Infra Applicatoins

RF Amplifier from Guerrilla RF

The GRF2105 from GuerrillaRF is an ultra-low noise linear amplifier that operates from 0.4 to 6 GHz. It has a P1dB of 23.5 dBm, OIP3 of 34.7 dbm, Noise figure of 0.78 dB with a gain of 20.6 dB. This device has a typical bias condition of 5 volts and 65 mA for optimal efficiency and linearity. It is available in a 1.5 x 1.5 x 0.5 mm 6-pin plastic DFN package.
 
Download Datasheet | Product Details
 
Power Divider
8 Way Power Divider 3.6 to 13.4 GHz

Power Divider from UMCC

The PD-MS00-8S from UMCC is an 8-way power divider that operates from 3.6 to 13.4 GHz. It has an insertion loss of 1.5 dB, Isolation of more than 18 dB, amplitude balance of ±0.20 dB and phase balance of ±4 degrees. This divider can handle an input power of up to 10 Watts with a VSWR of 1.5:1. It is available in a module with SMA female connectors.
 
Download Datasheet | Product Details
 
Vector Network Analyzer
PC Controlled Two Port Bidirectional VNA 400 to 4000 MHz

Vector Network Analyzer from MegiQ

The VNA-0440 from MegiQ is a two port bidirectional vector network analyzer that operates from 400 to 4000 MHz. It is controlled via a PC through a USB connector. This VNA is ideal for measuring all kinds of micro-circuits like antennas, attenuators, amplifiers etc. Its frequency range includes most popular telecom bands like GSM-GPRS-LTE, Wifi, DECT, GPS, ISM, Zigbee, Bluetooth.
 
Download Datasheet | Product Details
 
RF Mixer
RF SOI Image Reject Mixer from 10 to 19 GHz

RF Mixer from Peregrine Semiconductor

The UltraCMOS PE41901 is a SOI based passive double-balanced, Ku band mixer with image rejection. It integrates two mixers, a local oscillator (LO) path 90-degree coupler and RF port baluns on a single die. Integrating these functions provides good image rejection, reduces LO leakage and improves LO to RF isolation.
 
Download Datasheet | Product Details
 
Sponsored by Coilcraft
New Chip Inductors
New Chip Inductors Offer Highest L and Lowest DCR
Coilcraft’s new 0402DF Series chip inductors offer higher inductance values and significantly lower DC resistance than other 0402-sized inductors, making them ideal for RF choke and filtering applications. Offered in 25 inductance values from 20 to 3300 nH. Free samples available!
 
 
 
Signal Generator
USB-compatible Signal Generator 2 to 8 GHz

Signal Generator from Vaunix

The Lab Brick 802DX from Vaunix is a USB-compatible, synthesized signal generator that operates from 2 to 8 GHz. It has 100 Hz frequency resolution, 100 microsecond frequency switching and 10 dBm output with up to 80 dB of output level control. It is available in a compact module that measures 4.90 × 3.14 × 1.59 inches with SMA female connectors and is designed to fit into single rack unit for ATE applications.
 
Download Datasheet | Product Details
 
RF Amplifier
Class AB GaN Power Amplifier 6.4 to 7.1 GHz

RF Amplifier from Triad RF Systems

The TA1029 from Triad RF Systems is a class AB GaN power amplifier that operates from 6.4 to 7.1 GHz. It provides saturated power (Psat) of 44 dBm, a gain of 58 dB with a flatness of 2 dB. This amplifier requires a 28 V power supply and draws 2.3 A of current.
 
Download Datasheet | Product Details
 
Fixed Attenuator
2 Watt Attenuators from DC to 6 GHz

Fixed Attenuator from P1dB Inc.

The P1dB P1AT-SAMF-6G2W attenuator series operates from DC to 6 GHz and is capable of handling 2 Watts of CW power. The attenuators are available in an attenuation range from 0 to 10 dB with 1 dB increments plus in 12, 15, 20, 30 and 40 dB configurations. It has an equal electricity delay across all dB values, so it is a perfect solution for power levelling. They are available in a stainless steel body with SMA connectors.
 
Download Datasheet | Product Details
 
RF Switch
Absorptive SP4T Pin Diode Switch from 0.1 to 50 GHz

RF Switch from Planar Monolithics Industries

The P4T-100M50G-100-T-RD from Planar Monolithics is a SP4T switch that operates from 0.1 to 50.0 GHz. This absorptive pin diode switch has a low insertion loss, high isolation and can handle up to 20 dBm of power. It requires a supply voltage of -5V/+5 V and has a switching speed of 50 ns max.
 
Download Datasheet | Product Details
 
RF Transistor
300 Watt Low Cost GaN Power Transistor in a Plastic Package

RF Transistor from MACOM

The MAGe-102425-300 from Macom is a cost effective GaN power transistor. It provides output power of 300 Watts with a gain of 18 dB and efficiency of 70% at 2.45GHz. This transistor is available in a RoHS complaint cost effective plastic packaging optimized for use in commercial scale solid-state RF energy applications.
 
Product Details
 
RF Amplifier
1kW Solid State Broadband High Power Amplifier from 1 to 3 GHz

RF Amplifier from Empower RF

The BBS4A6AUT (SKU 2170) from Empower RF is a high power amplifier module which operates from 1 to 3 GHz. It ptovides up to 1000 Watts of CW power, 500 Watts of P1dB with a gain of 63 dB. The amplifier is ideal for signals with CW, AM, FM and pulse modulation.
 
Download Datasheet | Product Details
 
RF Amplifier
Low Noise Gain Block from 0.05 to 5 GHz

RF Amplifier from Guerrilla RF

The GRF3015 from GuerrillaRF is a low noise gain block amplifier that operates from 0.05 to 5 GHz. It has a P1dB of 22.7 dBm, OIP3 of 39 dBm, Noise figure of 1.2 dB and a gain of 17.9 dB. This device is operated from a supply voltage of 3 to 8 volts and draws 85 to 140 mA of current. It is available in a SOT-89 package and is ideal for use as a linear driver amplifier, broadband LNA or in DAS, small cell applications.
 
Download Datasheet | Product Details
 
Vector Network Analyzer
Compact Computer Controlled VNA from 20 kHz to 8 GHz

Vector Network Analyzer from Copper Mountain Technologies

The highly compact S5085 is a 2 port VNA that operates up to 8.5 GHz. It has a 120 dB dynamic range and designed for operation with any Windows PC or laptop. Its compact size allows it to be shared easily within a team or brought to test sites.
 
Download Datasheet | Product Details
 
RF Switch
SP5T Non-reflective Switch from DC to 18 GHz

RF Switch from Custom MMIC

The CMD235C4 is a Reflective SP5T that operates from DC to 18 GHz. It features a low power integrated 3:8 TTL decoder for enhanced digital control. The switch provides an insertion loss of 2.5 dB, has a high isolation of 40 dB at 10 GHz and a switching speed of 66 ns.
 
Product Details
 
RF Switch
SP160T Absorptive Switch 0.5 to 20 GHz

RF Switch from RF-Lambda

The RFSP160TA0020G from RF-Lambda is a SP160T absorptive switch that operates from 0.5 to 20 GHz. It has a low insertion loss of 28 dB (considering it is a SP160T switch), high isolation of 60 dB and can handle up to 0.5 W of CW power. This switch has a VSWR of 1.5:1 and a switching speed of less than 70 ns.
 
Download Datasheet | Product Details
 
Surface Mount Circulator
X-Band Surface Mount Circulator with low Insertion Loss and Small Package

Surface Mount Circulator from TRAK Microwave Limited

The X-Band Surface Mount (SMT) Circulator from TRAK Microwave is a low-cost, true SMT circulator compatible with tape-and-reel (pick-and-place) and standard solder reflow profiles. It has been designed to replace “drop-in” and microstrip style circulators.
 
Download Datasheet | Product Details
 
RF Spectrum Analyzer
Handheld RF/Microwave Analyzer from 4 to 50 GHz

RF Spectrum Analyzer from Keysight Technologies

The FieldFox Handheld RF and Microwave Analyzers from Keysight are available in a number of frequency options from 4 GHz to 50 GHz. These handhelp analyzers provide precise measurements which are comparable with benchtop equipment.
 
Download Datasheet | Product Details
 
About everything RF
everything RF is a product discovery platform for RF & Microwave products/Services. We list over 100,000 Products from more than 200 Companies across 200 Categories in our database and enable engineers to search for them using our customized parametric search tool.