1. everything RF
  2. RF Newsletters
more
PREV 23 Aug, 2017 NEXT

New RF & Microwave Products this Week

23 Aug, 2017 - everything RF Newsletter
 
everything RF
Date: 23 Aug, 2017
 
Sponsored by Copper Mountain Technologies
 
 
 
New RF & Microwave Products this Week
RF Mixer
Low LO Drive Passive GaAs MMIC IQ Mixer from 10 to 40 GHz

RF Mixer from Marki Microwave

The MMIQ-1040L from Marki Microwave is an ultra-broadband low LO drive, passive GaAs MMIC IQ mixer with a RF/LO frequency range from 10 to 40 GHz and IF range from DC to 12 GHz. It provides up to 30 dB of image rejection due to the excellent phase and amplitude balance of its on-chip LO quadrature hybrid. The mixer is available as a wire bondable die or connectorized modules.
 
Download Datasheet | Product Details
 
RF Mixer
1 MHz to 6 GHz USB Powered & Programmed RF Mixer

RF Mixer from Windfreak Technologies

The MixNV is a software programmable RF mixer which can up-convert, down-convert, or act as an RF Signal Generator. It can operate in a frequency range from 1 MHz to 6 GHz. The device has a built in Local Oscillator which can be controlled and powered by a PC running Windows, Linux or Android via its USB port.
 
Download Datasheet | Product Details
 
Vector Network Analyzer
10 MHz to 50 GHz, 2 Port and 4 Port Vector Network Analyzers

Vector Network Analyzer from Keysight Technologies

The N5245B from Keysight is a 2-Port and 4-Port Vector Network Analyzer that operates up to 50 GHz. This analyzer is part of the PNA-X Series of High Performance VNA's from Keysight with VNA's that operate up to 110 GHz. The PNA-X VNA's bring speed, accuracy, and ease-of-use to common RF measurements, in coaxial, fixtured, and on-wafer environments.
 
Download Datasheet | Product Details
 
RF Test Set
High-Performance Test Set for WLAN (802.11a/ac/b/g/j/n) and Bluetooth (v1.0 to v5) Devices

RF Test Set from LitePoint

The IQxel connectivity test system is a One Box Tester (OBT) that enables testing for the full range of 802.11 WLAN, Bluetooth (1.0 to 5), ZigBee, Z-Wave, WiSUN and DECT devices. It exceeds the demanding bandwidth and Error Vector Magnitude (EVM) requirements of 802.11ac equipped devices. IQxel covers both the 80 and 160 MHz versions of 802.11ac.
 
Download Datasheet | Product Details
 
RF Variable Attenuator
7-bit Digital PIN Attenuator from 0.5 to 20 GHz

RF Variable Attenuator from AtlanTecRF

The ADA-500-2000-60/0.5 from AtlanTecRF is a 7-bit Digital Control PIN Attenuator that operates from 0.5 to 20 GHz. The attenuator has an attenuation range of 60 dB with a 0.5 dB step size. The attenuator has a fast switching speed of under 200 ns and can handle an input power of up to 25 dBm. It is available in a module that measures 45 x 30 x 12 mm with SMA female connectors.
 
Download Datasheet | Product Details
 
Power Divider
30 Watt, 2 Way Power Divider from 6 to 40 GHz

Power Divider from MECA

The 802-5-23.000 from MECA is a 2 Way Power Divider that operates from 6 to 40 GHz. It can handle up to 30 watts of power and has a VSWR of less than 1.8:1. The divider has an insertion loss of 1.8 dB, Amplitude Balance of 0.5 dB and phase balance of 8 degrees. It is available in a module with 2.4 mm connectors. It is ideal for applications that use the Millimeter-wave band.
 
Download Datasheet | Product Details
 
Sponsored by Copper Mountain Technologies
Webinar for Universities about RF Laboratories
Webinar for Universities about RF Laboratories Using USB VNAs
Dr. Allen Katz will present how his lab at the College of New Jersey uses USB VNAs. Interested in hearing more about Dr. Katz and his RF program? Join us for his webinar as he discusses two port measurements, S parameters, impedance matching and the design projects his students participate in. Click here to learn more.
 
 
 
RF Cable Assembly
DC to 50 GHz Flexible VNA Test Port Extension Cables

RF Cable Assembly from MegaPhase

The High Performance VN Series Cable Assemblies from MegaPhase are VNA Test Port Extension Cables that operate up to 50 GHz. These VNA cable assemblies are designed to ease the time associated with test equipment calibrations where compensation for loss, mismatches, and feedthroughs are critical to the test outcome. The VN series cables are mechanically stable and can be bent with minimal effect on insertion loss, phase or VSWR. These cable assemblies can be available at custom lengths of up to 25 feet.
 
Download Datasheet | Product Details
 
Termination
100 Watt, RF Terminations from DC to 6 GHz

Termination from API Technologies - Inmet

The TNXXXY-100W series of RF Terminations from API Inmet operate from DC to 6 GHz and can handle up to 100 watts of average power and 1,000 Watts of Peak Power. The 50 ohm terminations have a VSWR of below 1.40:1 and can operate in a wide temperature range from -55 to 125 degrees C. They are available in a module with N-type Male or Female connectors.
 
Download Datasheet | Product Details
 
RF Amplifier
Compact Two-Stage Doherty Amplifier for LTE-A Pro Base Stations

RF Amplifier from Ampleon

The BLM9D2527-20AB from Ampleon is a two-stage doherty amplifier that operates from 2575 to 2634 MHz. Capable of also being used also as a power amplifier in small cells, this compact and highly efficient device is much smaller and easier to use than a traditional discrete Doherty amplifier design. It consists of a dual-stage Doherty amplifier with two stages of gain and is matched to 50 ohms at the input and output.
 
Download Datasheet | Product Details
 
Power Divider
2 Way to 32 Way Power Dividers from 0.6 to 6 GHz

Power Divider from VidaRF

This new series of Power Dividers from VidaRF operates from 0.6 to 6 GHz. They are available in 2, 3, 4, 6, 8, 12, 16 and 32 Way configurations and can handle up to 30 watts of power with a low insertion loss. These dividers also provide high port to port isolation and low amplitude and phase balance. They are available in a sealed and painted IP65 compliant module with SMA connectors.
 
Download Datasheet | Product Details
 
Antenna
Low-Profile Multi-Band MIMO Antenna for LTE, Wi-Fi and GNSS

Antenna from PCTEL

The GNSMB-COV is a new multi-band LTE/Wi-Fi/GNSS antenna that supports multi-band LTE MIMO, dual-band 2.4/5 GHz Wi-Fi for data connectivity, as well as GPS, GLONASS, BeiDou, and Galileo GNSS satellite technologies. It delivers a gain of 6 dBi and can handle up to 10 watts of power. This antenna has a sub 1-inch height profile and is ideal for covert public safety operations, heavy construction, precision agriculture, and the Industrial IoT applications.
 
Download Datasheet | Product Details
 
RF Amplifier
Ultra-Low Noise Amplifier from 3 to 6 GHz

RF Amplifier from Guerrilla RF

The GRF2073 from Guerrilla RF is an ultra-low noise amplifier that operates from 3 to 6 GHz. It provides a P1dB of 18 dBm with a gain of 18.6 dB and has a noise figure of 0.63 dB. The LNA requires a supply voltage of 6 V and consumes up to 500 mW of power. It is available in a surface mount package and is ideal for distributed antenna systems, small cells, 3.5 GHz CBRS and cellular repeater applications.
 
Download Datasheet | Product Details
 
Sponsored by Copper Mountain Technologies
 
 
 
Signal Generator
High-Performance RF Signal Generator from 100 kHz to 3 GHz

Signal Generator from Saluki Technology

The Saluki S1131 is a high-performance RF signal generator that operates from 100 kHz to 3 GHz. It provides multiple functions such as CW signal generation, AM/FM analog modulation, ASK, FSK, PSK digital modulation, pulse modulation, frequency / amplitude sweep and more. This signal generator supports SCPI, which makes it easy to build your own program for remote control applications. It is also a good option for education and RF component manufacturing.
 
Download Datasheet | Product Details
 
RF Mixer
3 to 20 GHz, Double Balanced Mixer for Up or Down Conversion Applications

RF Mixer from Linear Technology

The LTC5552 from Linear Technology is a double balanced mixer with wideband matching from 3 GHz to 20 GHz. The mixer can be used for both up and down conversion applications. When used in up conversion applications its DC capable differential IF port enables the LO to be close in frequency to the RF. Its low LO to RF leakage of less than -25 dBm greatly eases the burden on the external filter.
 
Download Datasheet | Product Details
 
Power Divider
2-Way Power Divider from 2 to 2500 MHz

Power Divider from MiniRF

The MRFSP8525 from MiniRF is a 2-Way Power Divider that operates from 2 to 2500 MHz and can handle up to 1 watt of power. It has an insertion loss of less than 2 dB with an isolation of more than 15 dB. The divider is available in a small surface mount package and is ideal for broadband, wireless and other communications systems.
 
Download Datasheet | Product Details
 
About everything RF
everything RF is a product discovery platform for RF & Microwave products/Services. We list over 100,000 Products from more than 200 Companies across 200 Categories in our database and enable engineers to search for them using our customized parametric search tool.