| New Aerospace & Defense Products . |
|
|
|
|
|
|
|
| 3U OpenVPX Multi-Channel Programmable Digital Transceiver | |
RF Transceiver
from Mercury Systems
|
| The EnsembleSeries™ DCM3220 from Mercury Systems is a Multi-Channel Programmable Digital Transceiver optimized for SWaP-constrained environments. It consists of FPGA processing (Virtex Ultrascale VU7P FPGA, Zynq Ultrascale ZU11EG MPSoC, and 7488 DSP slices), VITA 65 backplane, 12-bit ADC and DAC, VITA 67 configurable rear I/O, security engine, and an AS9100D-qualified IPMI controller. |
| |
Download Datasheet
Product Details | |
|
|
|
| Rugged, Ethernet-Powered Beam Steering Outdoor Radio from 4.4 to 5.875 GHz | |
Microwave Backhaul Radio Links
from Cambium Networks
|
| The PTP 45700 from Cambium Networks is a Beam Steering Outdoor Radio Unit (ODU) that operates from 4.4 to 5.875 GHz. It has an integrated smart antenna that provides electronic beamforming and allows for easy tactical installation and excellent interference mitigation. This antenna has an azimuth range of 120° and an elevation range of 30° for point-to-point links and enables quick, tactical installation by pointing in the general direction of the desired radio. |
| |
Download Datasheet
Product Details | |
|
|
|
| Encrypted Radio from 1350 to 4990 MHz for Ground or Airborne Applications | |
Software Defined Radio
from Collins Aerospace
|
| The RT-2071(C) Secure CDL ISR SCISR Radio from Collins Aerospace operates from 1350 to 4990 MHz. It provides low-cost and lightweight wideband data link capability that is suitable for a wide range of applications. This radio can be configured as either a ground or airborne terminal and can be matched with a variety of antenna and power amplifiers to meet the requirements of wideband data throughput applications. |
| |
Download Datasheet
Product Details | |
|
|
|
|
|
| Low Noise Amplifier from 0.4 to 3 GHz for Space and Military Applications | |
RF Amplifier
from Teledyne e2v HiRel Electronics
|
| The TDLNA0430 from Teledyne e2v HiRel Electronics is a Low Noise Amplifier that operates from 0.4 to 3 GHz. It provides a small signal gain of 21.5 dB with a noise figure of 0.35 dB and has a P1dB of 18.5 dBm. This LNA utilizes application-specific biasing and can be biased over an operating voltage of 5 V. It can be used as the first-stage LNA for advanced satellite or military communication receivers or radar systems applications. |
| |
Download Datasheet
Product Details | |
|
|
|
|
|
|
|
|
| Rugged 50 GHz Fixed Chip Attenuators for Space and Defence Applications | |
Fixed Attenuator
from Smiths Interconnect
|
| The HR TXS Series from Smiths Interconnect are Fixed Chip Attenuators that operate up to 50 GHz. They are available in attenuation values from 1 to 20 dB and can handle input power of up to 3 W. These chip attenuators use robust thin-film process technology on an alumina substrate to provide a product suitable for harsh environments, such as space and defence applications. |
| |
Download Datasheet
Product Details | |
|
|
|
| 50 GHz Rugged and Armored Test Cables for Flight Line Testing | |
RF Cable
from MegaPhase
|
| The SiteLine™ Series from MegaPhase are Armored Test Cables that operate up to 50 GHz. They are protected by super-rugged armor designed for severe environments, such as flight line, outdoor antenna testing, and demanding production environments. These 50-ohm cables can endure torque, twist, and crush forces and are crush-proof to 44.6 Kg/linear cm. |
| |
Download Datasheet
Product Details | |
|
|
|
| 1.25 W Power Amplifier from 2 to 20 GHz | |
RF Amplifier
from Narda-MITEQ
|
| The MPAS-40-02002000-45-30P from Narda-MITEQ is a Power Amplifier that operates from 2 to 20 GHz. It provides a gain of 44 dB with an output P1dB of 31 dBm. This power amplifier has an ON/OFF switch with a switching time of less than 200 µs and a rise/fall time of less than 100 µs. It features reverse polarity protection, over-temperature alarm/protection, and over/under-current alarm. |
| |
Download Datasheet
Product Details | |
|
|
|
|
|
|
|
|
| Ruggedized OCXO from 60 to 220 MHz | |
OCXO
from SiTime
|
| The SiT7112 from SiTime is an Oven Controlled Crystal Oscillator (OCXO) that operates from 60 to 220 MHz. It produces an LVCMOS or clipped sinewave output and has a frequency stability of ±1 ppb (from -40°C to + 95°C). This OCXO leverages SiTime’s unique temperature sensing technology and advanced CMOS design to deliver excellent stability in extreme environments. |
| |
Download Datasheet
Product Details | |
|
|
|
| Low Phase-noise Sinewave OCXO from 80 to 160 MHz | |
OCXO
from AXTAL
|
| The AXIOM5050ULN from AXTAL is an Oven Controlled Crystal Oscillator (OCXO) that operates from 80 to 160 MHz. It provides a sinewave output with a frequency stability of ±50 ppb (vs. temperature) and has a phase noise of -137 dBc/Hz (at 100 Hz offset). This OCXO has a warm-up time of up to 5 min and a g-sensitivity of 1 ppb/g. |
| |
Download Datasheet
Product Details | |
|
|
|
| Benchtop 400 MHz, 4-Channel Frequency Analyzer | |
Frequency Counter
from Pendulum Instruments
|
| The CNT-104S from Pendulum Instruments is a 4-channel 400 MHz Frequency Analyzer. It can simultaneously track parallel frequency, phase, or time on 4 input channels and provides gap-free measurements for back-to-back measurements without losing any cycle. This analyzer has a time resolution of up to 7 ps resolution, a frequency resolution of up to 13 digits/s frequency resolution, and a measuring speed of 20M results/s. |
| |
Download Datasheet
Product Details | |
|
|
|
| L1/L2-Band Military-Grade, GPS Disciplined Rubidium Time and Frequency Clock | |
Rubidium Oscillator
from AccuBeat
|
| The AR51-09 from AccuBeat is a military-grade, GPS Disciplined Rubidium Time and Frequency Clock that operates in the L1 and L2 bands. It can be disciplined to a GPS or an external synchronization source with a time accuracy of 1 PPS and a frequency accuracy of ±1 x 10-12. This system has spurious levels of less than -100 dBc, harmonics of -53 dBc, and phase noise of -140 dBc/Hz (at 1 kHz offset). |
| |
Download Datasheet
Product Details | |
|
|
|
| C-band Solid-State Transponders from 5.4 to 5.9 GHz | |
Radar Transponder
from Curtiss-Wright Defense Solutions
|
| The XPDR-520 Series from Curtiss-Wright are C-band Transponders that operate from 5.4 to 5.9 GHz. These solid-state transponders deliver a pulsed RF output power of 20 W and have a sensitive superheterodyne receiver and crystal-controlled frequency stability. They are mismatch-protected from high antenna VSWR and do not require pressurization. |
| |
Download Datasheet
Product Details | |
|
|
|
| Ruggedized, Multi-Band Handheld Transceiver from 30 to 512 MHz | |
Software Defined Radio
from Datron
|
| The HH3100 from Datron is a Handheld Transceiver that operates in the VHF Band from 30 to 512 MHz. It offers 100 programmable channels at 25 kHz or 12.5 kHz spacing. This transceiver supports simplex and half-duplex modes and provides a user-selectable output power of 500 mW to 7 W. It provides accurate position and time-of-day capability using the embedded GPS receiver. |
| |
Download Datasheet
Product Details | |
|
|
|
| X-Band Electronically Tunable Filter from 8 to 10 GHz | |
Tunable Filter
from Nanowave Technologies
|
| The NWETF8010-10 from Nanowave Technologies is an X-Band Electronically Tunable Filter with center frequencies from 8 to 10 GHz. It allows the center frequency to be adjusted electronically and has an adjustable 3 dB bandwidth from 10 to 100 MHz. Both the bandwidth and frequency of the filter can be electronically controlled in frequency steps of less than 1 MHz. |
| |
Download Datasheet
Product Details | |
|
|
|
| Ruggedized Multi-Channel Datalink Transponder from 358 to 380 MHz | |
Data Link
from KRATOS General Microwave
|
| The MODEL 290-3 from Kratos is a UHF Datalink Transponder with a frequency range from 358 to 380 MHz. It is a command receiver, digital command decoder, digital telemetry encoder, telemetry transmitter, and target interface enclosed in a single lightweight package. This transponder has 16 frequency channels and supports the GMSK modulation scheme. |
| |
Download Datasheet
Product Details | |
|
|
|
|
|
|
|
|
| Ku-/Ka-Band Aviation SATCOM Terminal from 10.95 to 31.0 GHz | |
SATCOM Terminal
from Viasat
|
| The 5530 (GAT-5530) from Viasat is an Aviation SATCOM Terminal that operates from 10.95-14.5 GHz (Ku-band) and 17.7-31.0 GHz (Ka-band). It delivers an EIRP of 52.5 dBW (Ka-band) with a G/T of 11.0 dB/K (Ku-band) and 12.5 dB/K (Ka-band). This SATCOM terminal has a medium profile dual-band Tx/Rx airborne antenna and a waveguide horn array aperture with electronically switchable linear (Ku-band) and circular (Ka-band) polarization. |
| |
Download Datasheet
Product Details | |
|
|
|
| Ruggedized Ground Data Terminal from 14.4 to 15.35 GHz | |
SATCOM Terminal
from Cubic
|
| The Mantis II from Cubic is a Ground Data Terminal that operates from 14.4 to 15.35 GHz. It supports long-range, high-data-rate communications with airborne platforms equipped with a multitude of DoD standard Common Data Link (CDL) waveforms. This terminal provides an operating range of up to 250 nmi or more (depending on system configuration) and delivers a full-duplex data rate from 200 Kbps to 44.73 Mbps. |
| |
Download Datasheet
Product Details | |
|
|
|
| Sub-6 GHz Military-Grade Antennas for Electronic Warfare Applications | |
Antenna
from Fairview Microwave
|
| The FMANOM114X Series from Fairview Microwave are Military-Grade Antennas that operate from 1.15 to 6 GHz. These vertically polarized antennas have an omnidirectional radiation pattern and provide a gain of 3.5 dBi. This antenna series consists of ruggedized GPS, manpack, and vehicle-mount antennas designed for mission-critical applications. They meet the MIL-STD-810 standard with heavy-duty construction and a rugged design for long-lasting performance in challenging environments. |
| |
Download Datasheet
Product Details | |
|
