| New Satellite & Space Products . |
|
|
| SATCOM Antenna from 17.7 to 31 GHz with Anti-Jam Capabilities | |
SATCOM Antenna
from ThinKom
|
| The ThinAir GT 2517 from ThinKom is a SATCOM Antenna that operates from 17.7 to 21.2 GHz (Rx) and 27.5 to 31 GHz (Tx). It is approved to operate on commercial and government networks, including LEO, MEO and GEO constellations. This antenna ensures a low probability of intercept/detection and features inherent anti-jam robustness to operate in demanding EMI, EMC, and EMP environments. |
| |
Download Datasheet
Product Details | |
|
|
|
|
|
|
|
|
| Ruggedized Ground Data Terminal from 14.4 to 15.35 GHz | |
SATCOM Terminal
from Cubic
|
| The Mantis II from Cubic is a Ground Data Terminal that operates from 14.4 to 15.35 GHz. It supports long-range, high-data-rate communications with airborne platforms equipped with a multitude of DoD standard Common Data Link (CDL) waveforms. This terminal provides an operating range of up to 250 nmi or more (depending on system configuration) and delivers a full-duplex data rate from 200 Kbps to 44.73 Mbps. |
| |
Download Datasheet
Product Details | |
|
|
|
|
|
|
|
|
| Radiation-Tolerant Transceiver 2025 to 2290 MHz for SATCOM Applications | |
SATCOM Transceiver
from Space Micro
|
| The NANOCOM from Space Micro is an S-Band Transceiver that operates from 2200 - 2290 MHz (Tx) and 2025 - 2100 MHz (Rx). It has a bandwidth of 50 MHz and supports BPSK, QPSK and OQPSK modulation schemes. This radiation-tolerant transceiver has been designed to perform in extreme environmental conditions. It has an on-board 50 MHz TCXO and a Xilinx Zynq System on a Chip (SoC). |
| |
Download Datasheet
Product Details | |
|
|
|
| 1 kW Antenna-Mountable Ku-Band Block Upconverter (BUC) | |
Block Up Converter
from Mission Microwave
|
| The MOAB-Ku-1 KW from Mission Microwave is a Block Upconverter (BUC) that operates in the Ku-Band from 13.75 to 14.5 GHz (or 14.0-14.5 GHz). It delivers an output power of 1000 W (~60 dBm). This BUC has Ethernet and serial interfaces and can be connected with Mission’s GUI on a remote PC for monitoring and control. |
| |
Download Datasheet
Product Details | |
|
|
| Download Now: New Satellite & Space eBook | | |
|
|
| Block Upconverter with Flexible Module Configurations from 12.75 to 14.5 GHz | |
Block Up Converter
from ETL Systems
|
| The FN-U-K1L1-24407 (Falcon2) from ETL Systems is a Block Upconverter (BUC) that converts input frequencies from 1150 to 2150 MHz to output frequencies from 12.75 to 14.5 GHz. It provides a conversion gain of up to 35 dB with a gain step size of 0.25 dB and has a noise figure of less than 12 dB. This BUC has a phase noise of -110 dBc/Hz (at 1 MHz offset) and provides an image rejection of more than 60 dB. |
| |
Download Datasheet
Product Details | |
|
|
|
| Block Up Converter from 27.5 to 31 GHz for LEO/MEO/GEO Applications | |
Block Up Converter
from Communications & Power Industries
|
| The SA52KOA from Communications & Power Industries is a Block Up Converter (BUC) that converts input frequencies to output frequencies from 27.5-30 GHz/29-31 GHz. It delivers a linear output power from 80-100 W with a gain of more than 63 dB and a gain adjustment range of up to 30 dB (in 0.1 dB steps). This BUC is manufactured using GaN technology and uses proprietary RF techniques to provide high linear power and efficiency in a small, lightweight outdoor package. |
| |
Download Datasheet
Product Details | |
|
|
|
| Ku-Band Block Up-Converter (BUC) from 13.75 to 14.5 GHz | |
Block Up Converter
from Amkom Design Group Inc
|
| The ASKU20 from Amkom is a Ku-Band Block Up-Converter (BUC) with an RF Frequency of 14 to 14.5 GHz (standard) or 13.75 to 14.5 GHz (extended). It delivers an output power of 43 dBm (20 W) and a linear power of 42 dBm (16 W). This feed-horn & boom-arm mountable BUC has an IF frequency of 950 to 1700 MHz and has GaAs + GaN high-power amplifiers with internal overdrive protection. |
| |
Download Datasheet
Product Details | |
|
|
|
|
|
|
|
|
|
|
|
|
|
| Ku-Band PLL Low-Noise Block from 11.70 to 12.20 GHz | |
Low Noise Block
from Actox
|
| The ALP20500/ALP20500N from Actox is a Ku-Band PLL Low-Noise Block (LNB) that operates from 11.70 to 12.20 GHz. It has an LO frequency of 10.75 GHz and an IF frequency of 950 to 1450 MHz. This LNB delivers an output P1dB of over +0 dBm with a conversion gain of 60 dB and has a phase noise of less than -88 dBc/Hz. It has a stability of +/-500 KHz and a gain flatness of less than 3 dB p-p. |
| |
Download Datasheet
Product Details | |
|
|
|
| Low Noise Block Downconverters from 38 to 40 GHz | |
Low Noise Block
from ACORDE
|
| The ACLNBD-Q Dual-Band Series from ACORDE are Low Noise Block (LNB) Downconverters that convert input frequencies from 38-40 GHz to output frequencies from 950-1950 MHz. They provide a gain of more than 60 dB with a noise figure of less than 2.8 dB and have a phase noise of -80 dBc/Hz (at 10 kHz offset). |
| |
Download Datasheet
Product Details | |
|
|
|
|
|
|
|
|
| 25 W GaN Power Amplifier from 45 to 46.5 GHz for SATCOM Applications | |
SATCOM Amplifier System
from TTI
|
| The Q-Band SSPA from Celestia TTI operates from 45 to 46.5 GHz. This solid-state power amplifier delivers an output power of 25 W (~44 dBm) with a small signal gain of more than 70 dB and provides an attenuation range of 25 dB in 0.1 dB steps. It is based on GaN technology and ensures robust performance with individual unit testing over the operating temperature (from -30°C to +55°C). |
| |
Download Datasheet
Product Details | |
|
|
|
| 100 W GaN Solid-State Power Amplifier from 27.5 to 31.0 GHz | |
SATCOM Amplifier System
from ACORDE
|
| The ACSH-Ka100W-Ex-V3 from Acorde is a Solid-State Power Amplifier that operates in the Ka-Band from 27.5 to 31.0 GHz. It delivers a saturated output power of 100 W (~50 dBm) with a gain of more than 65 dB. This SSPA is based on GaN technology and achieves excellent power efficiency, phase noise, gain stability and linear power according to MIL-STD-188-164C. |
| |
Download Datasheet
Product Details | |
|
|
|
| 400 W TWT High Power Amplifier from 13.75 to 14.5 GHz | |
SATCOM Amplifier System
from ND SatCom GmbH
|
| The HPA 4413A from ND SatCom is a Power Amplifier (PA) that operates in the Ku-Band from 13.75 to 14.50 GHz. It delivers an output power of 400 W (TWT) with a small signal gain of more than 72 dB. This amplifier consists of a high-voltage section potted with all other electrical components coated to protect against humidity and dust. |
| |
Download Datasheet
Product Details | |
|
|
|
| 1+1 Redundant L-Band Rackmount Amplifier System from 950 to 2150 MHz | |
SATCOM Amplifier System
from RF-Design
|
| The HQR245C-FT from RF Design is a 1+1 Redundant Rackmount Amplifier System that operates from 950 to 2150 MHz. It consists of two amplifiers, each providing a variable gain from 0 to 40 dB in 0.1 dB steps, with a noise figure of 3 dB and has an output P1dB of more than +21 dBm. The system can be used as a 1+1 redundant RF line amplifier or 2 single high-precision amplifiers. |
| |
Download Datasheet
Product Details | |
|
|
|
|
|
|
|
|
|
|
|
|
|
| Space-Qualified Integrated Transmitter Module from 26.7 to 26.9 GHz | |
RF Transmitter
from ERAVANT
|
| The SSK-ST2730253027-28-C1 from ERAVANT is a Space-Qualified Transmitter Module with a frequency range from 26.7 to 26.9 GHz. It is designed and manufactured for small satellite applications and incorporates a phase-locked oscillator to convert 1.0 GHz signals to 26.8 GHz signals. This module has an integrated circular-polarized, lens-corrected antenna with a 3 dB beamwidth of 10°. |
| |
Download Datasheet
Product Details | |
|
